O attention – Инструкция по эксплуатации TIMBERK TAP FL300 MF
Страница 12
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
Turning on and offthe device
Connect theequipment into an outietCiick on-off unit, air cieanerwiil work.
Press the button again, the device turns off.
Sensor mode
Ciick Sensor, after 3 minutes the sensor wiii determine the quaiity of air, up to
this point indicator of air quaiity (Fig. 1, item 1) can giow red. After 3 minutes,
if the indoor air ciean and cióse to the net - the LED wiii giow biue, when the
air is very dirty-the LED wiii giow red, ifthe air is poiiuted, but not much-the
LEDwiiigiowpurpie.
When the sensor mode other modes, which are controlied by pressing the
Mode, wiii network.
in the sensor unit automaticaiiy adjusts the fan speed and, consequentiy, the
performance of air cieaning. ifthe air is ciean (biue LED), the unit shuts down
or wiii be run at iow fan speed, if air poiiution is not much (vioiet iight), the
unit wiii operate with iow or medium fan speed, ifthe air is heaviiy poiiuted
(red), the device wiii operate at high fan speed.
Ciick Sensor again to exit this mode.
The user can adjust the sensitivity of the sensor in air quaiity. The button
adjustment of sensor sensitivity (Low - High) is behind the front panei (see
Fig. 7).
Fig.7
Кнопка регулировки
чувствительности сенсора
(Low-High)
ifthe button adjustment of sensor sensitivity is set to Low - iow sensitivity of
the sensor ifthe sensor sensitivity adjustment button is set to High - High
sensitivity of the sensor. From this setting may depend on the intensity of
the device and coior dispiay mode, air quality sensor Sensor.
o
ATTENTION!
Air quality sensor has an internal memory, so the sensitivity is not always
able to change immediately after the switch button Low-High. To
quickly activate the newly defined set of sensor sensitivity, unplug from
the wall outlet, then plug in again. Sensitivity of the sensor will change.
Cleaning the sensor
Fig. 8
I' ^
и
г
s
Air quality sensor should be cleaned 1 time in two months.Todo this, opena
window on the side of the sensor device (Fig. 8).
Clean with a damp cloth, then wipe the sensor must dry cloth.
Color Mode setting
With the mode button MODE (Fig. 2, item 3) Select the manual installation
(Fig. 3, Section 21) lights up the appropriate indicator. In this mode, the unit
will run continuously until it is turned off by the user.
Automatic mode AUTO
With the mode button MODE (Fig. 2, item 3) to select automatic operation,
lights up the corresponding LED (Figure 3, paragraph 20). In this mode, the
device will work for 20 minutes and then stops for 40 minutes. The cycle is
repeated. To exit this mode you must select another mode with the same
button.