Beko CG 51010 - Инструкция (Страница 40)

Oven intenor
Before switching on again ensure that all controls
are in the OFF position. Take out all trays and
the grill out of the oven. Clean out the interior
with a piece of moist, soapy cloth. Then, clean
it once more with a wet piece of cloth and let
it to dry.
Do not use dry powder agents for
cleaning.
Special cleaners that are commercially available
may be used after carefully reading the warning
that are written on the labels.
Warning!
Never clean the inside of the oven and trays with
hard brushes, steel pads or knives.
Special cleaners that are commercially avaible
may be used after carefully reading the warning
that are written on the labels.
Calalytic-enamelled models (if available); The
oven interior of this model is coated with
catalytic enamel since the catalytic enamel
cleans itsellf, you do not have to perform an
extra cleaning after the cooking operation.
If your oven obtains steel
rack;
To clean the steel
rack, unscrew the 4 screws.
After cleaning operation,
assemble the steel rack to
the oven body again.
Control panel
Wipe over the control panel with a
damp cloth and polish with a dry cloth. Do
not use oven cleaners or aerosols, scouring
pods or abrasive powder for cleaning the
plastic knobs as damage will occur. Do not
attempt to remove any of the control knobs
from the panel as this may cause damage
and is a safety hazard.
Oven deer
Wipe over the door outer panel with a cloth
wrung out in hot soapy water, then after
wiping with a
cloth wrung out in clear water. Do not use
scouring pads or abrasive powder which
may scratch the surface. Take care during
cleaning not to damage or distort the door
seal.
Repla€ing fhe oven lamp:
1. Unplug the power coble.
2 . Then, remove theprotective glass cover of the lamp
inside your oven by turning it counterclockwise.
3 . Then, remove the bulb by turning it counterclockwise.
4
. After installing the correct bulb obtained from on
Authorized Service, reinstall the protective gloss of the
lamp.
16