Operating the grill (it available – Инструкция по эксплуатации Beko CG 51010

Страница 37

Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".

Advertising
background image

Operating the Grill (it available^:

Turn the oven and grill control knob by pressing and rotating in to the grill

position.

for the models without ignition;

While the knob is pressed position, ignite the burner by lighter or a

match and wait to ignite,

for the models with electrical ignition;

While the knob is in pressed position, press the ignition button.

After the gas in the grill burner is ignited, keep the knob in the pressed

position for 5-10 seconds. After you release the knob, if the ignition does

not continue repeat the same process by keeping the knob pressed for

15 seconds. If still no igniton occurs, wait for 1 minute and repeat again

Warning: Do not keep the knob in pressed position more

than 15 seconds.

«•"

After ignition close the door perform a 10 minutes

preheating.

Apply oil on the grill shelf to prevent

sticking on the bars.

Locate the grill shelf to the 3 or 5th shelf on the oven.

Locate a tray to one of the bottom shelves in order to

collect to oils and for easy cleaning put some water in it.

Using the Knob Heat Shield housing

into Oven Door (for suitable models)

WARNING!

Do not grill when the front

door is closed. Otherwise, oven parts
may be damaged. After preheating, keep
the front door half-open during grilling.
In order to prevent the knobs of the control

panel from heating up, center the knob

shield plate between the front cover and

the oven housing without leaving any

gap.

Using the Knob Heat Shield housing into Oven Body (for suitable models)

WARNING I:

After preheating,

keep

the front door fully open during grilling.

In order to prevent the knobs of the
control panel from heating up, the knob
heat shield plate must be placed in the
housing where the bottom of the control

panel shown in the figure.

Control panel

WARNING

!: After preheating,

keep

the front door fully open during grilling.

In order to prevent the knobs of the
control panel from heating up, the knob
heat shield plate must be placed in the

pins at the bottom of the control panel

shown in the figure.

Knob beat shield \ Front door

Knob heat shield

-f3

Advertising
Эта инструкция подходит к следующим моделям: