Recording, Select the source to be recorded, Press [• g3] to start recording – Инструкция по эксплуатации Panasonic RX-DX1
Страница 13
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
1
Side to be recorded
facing you
To re-record
Normal tape
Adhesive tape
Recording
You can record radio broadcasts or CDs.
Before recording
• This unit is suitable for recording norma! tapes, but it cannot
record onto high and metal position tapes to their full
potential and prior recordings will not be erased correctly.
• The recording level is set automatically.
• Take up the leader tape before proceeding.
Your attention is drawn to the fact that recording pre
recorded tapes or discs or other published or broad
cast material may infringe copyright laws.
1
Press [B/ib STOP/EJECT] to open the deck
and load a cassette.
Close the deck by hand.
Select the source to be recorded.
When recording radio broadcasts
Tune in the station.
(Do steps 1-2 of “The Radio: manual tuning” on page
10
. )
When recording CDs
Press [►/!!] and then [■ ALARM STOP] to switch to
CD mode.
Insert the CD to be recorded.
(Do step 1 on page 8.)
If you want to record programmed tracks, program
desired tracks before proceeding to step 3.
(Do steps 1-2 on page 9.)
Press [• G3] to start recording.
[◄ PLAY] is also depressed with [•
1333].
Recording starts (one side only).
The CD also starts playing if in CD mode.
To stop recording
Press [H/^ STOP/EJECT]. (The CD does not stop.)
To stop recording temporarily
Press [II PAUSE]. (The CD does not stop.)
Press once again to resume recording.
To record on the other side of the cassette
Turn the cassette over and press [• E3].
If the CD finishes before the cassette
Recording continues. Press p/± STOP/EJECT] to stop it.
If the cassette finishes before the CD
The CD continues playing. Press [■ ALARM STOP] to stop
it.
Noise may be recorded if this unit is near a TV. Keep the
units at least 1.5 meters apart.
D Erasure prevention
Use a screwdriver or similar object to break out the tab.
El
To re-record on a protected cassette
Cover the hole with adhesive tape.
To erase a cassette
1. Press [TAPE/OFF DOZE],
2. Insert the cassette with the side to be erased facing towards
you and the exposed tape facing up.
3. Press [• 123].
[◄ PLAY] is depressed at the same time.
O)
c
■H
o
o
Q)
QC
Reference
Changes to volume and sound quality do not affect recording.
To prevent interruptions to recording, supply AC power to
the unit or replace the batteries.
RQT6232