Petsafe Stubborn Dog In-Ground Fence™ System - Инструкция (Страница 156)

To locate a Break in the Boundary Wire
Please follow these steps in determining where you have a break in your Boundary Wire:
1. Locate your original splice(s) and verify they have a good, solid connection.
2. Check your garden to determine any possible damage to the Boundary Wire (e.g. recent digging, aerating, rodent burrowing, or any other
noticeable disturbance in your yard next to the Boundary Wire).
If you still cannot find the break in the Boundary Wire, there are two options for locating it:
Option 1: Contact the Customer Care Centre to purchase a Wire Break Locator that will locate the break in the Boundary Wire.
Option 2: Follow the procedure below:
1. Unplug the Fence Transmitter.
2. Connect both ends of your twisted Boundary Wire to one Boundary Wire Terminal.
3. Measure and cut a Test Wire which is half the length of your total Boundary Wire footage.
4. Connect one end of Test Wire to the other Boundary Wire Terminal.
5. Locate the halfway point of your boundary and cut the Boundary Wire.
6. Splice the other end of the Test Wire to either side of your Boundary Wire where you cut it in half.
7. Plug in the Fence Transmitter and check the Loop Indicator Light. If the Loop Indicator Light is on, you can
assume the break is in the other half of the Boundary Wire.
8. If the Loop Indicator Light did not come on, you may assume there is a break in this portion of the Boundary
Wire. However, there is a small chance of having more than one break in your system. Be sure to check both
halves of your entire loop.
9. Replace the damaged Boundary Wire with new Boundary Wire.
10. Reconnect the Boundary Wire to the Fence Transmitter.
11. Check the Loop Indicator Light. If the Loop Indicator Light is on, test the system with the Receiver Collar.
Battery Disposal
Separate collection of spent batteries is required in many regions; check the regulations in your area before discarding spent batteries. Please
see page 141 for instructions on how to remove the battery from the product for separate disposal. This device operates on one 9 Volt
alkaline battery. Replace only with equivalent battery.
important Recycling advice
Please respect the Waste Electrical and Electronic Equipment regulations in your country. This equipment must be recycled. If you no longer
require this equipment, do not place it in the normal municipal waste system. Please return it to where it was purchased in order that it can be
placed in our recycling system. If this is not possible, please contact the Customer Care Centre for further information. For a listing of Customer
Care Centre telephone numbers, visit our website at www.petsafe.net.
Compliance
This equipment has been tested and found to comply with the EU R&TTE Directive. Before using this equipment outside the EU countries, check
with the relevant local R&TTE authority. Unauthorised changes or modifications to the equipment that are not approved by Radio Systems
Corporation may violate EU R&TTE regulations, could void the user’s authority to operate the equipment, and will void the warranty.
Hereby, Radio Systems Corporation, declares that this PRF-3004XW-20 Stubborn Dog In-Ground Fence is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/EC.
The Declaration of Conformity can be found at: http://www.petsafe.net/customercare/eu_docs.php.
Test
Wire
156 www.petsafe.net
FI
DA
SV
RU
NO
EN