Pet fountain reassembly, Fi da sv ru no en – Инструкция по эксплуатации Petsafe Drinkwell® Mini Pet Fountain
Страница 70
www.petsafe.net
71
70
www.petsafe.net
FI
DA
SV
RU
NO
EN
4. Remove the Intake Plate by placing your fingernail underneath the small lip
located on the narrow side of the teardrop-shaped Intake Plate Pull-Tab and pull it
out (
Fig. 10-11).
5. Once the Intake Plate is removed, you can also
remove the Impeller (white, 3-bladed propeller)
which is held in place magnetically. To remove the
Impeller, use a fingernail to get underneath a blade
and lift out (
Fig. 12).
6. Once the Pump is disassembled you can clean
the parts with warm water and soap. Use a cotton
swab or the “motor” brush from the Drinkwell
®
Cleaning Kit to get into the Pump’s motor cavity
and remove any build-up (
Fig. 13). For added
disinfecting and hard water removal, clean the
Pump witha diluted vinegar solution (20% white
vinegar and 80% water).
7. Once the parts are clean you can reassemble the
Pump for use.
a) Replace the Impeller.
b) Replace the Intake Plate.
c) Replace the Faceplate with the Flow Control Knob.
Pet Fountain Reassembly
1. Replace the Pump into its location between the four posts on the right side of the Pet
Fountain Bowl. Gently push down on Pump to engage the suction
cups (
Fig. 14 & 15).
Intake Plate
Pull-Tab
Fig. 10
Fig. 11
Fig. 12
Fig. 13
Fig. 14
Fig. 15
Pump
.