Operating instructions – Инструкция по эксплуатации Petsafe Drinkwell® Mini Pet Fountain

Страница 67

Advertising
background image

www.petsafe.net

67

SV

RU

NO

EN

FI

DA

Operating Instructions

Important: DO NOT RUN DRY - FOR INDOOR USE ONLY. Pet Fountain will come
fully assembled and ready for use.
1. As with any electrical device, check the electrical Power Cord for any tears or

damage before use.

2. Make sure the In-Line Plug is fully connected. When connected properly the silver tip

is not showing.

3. Remove the Housing Lid by placing your index fingers into the inset grooves on either

side of the Housing Lid. Lift up. Set the Housing Lid aside.

4. Insert the Charcoal Filter into the Housing. The Charcoal

Filter will fit into the two triangular slots located on the
right side of the Housing. The Charcoal Filter fits narrow
side down and the white side faces the front of the Pet
Fountain (

Fig. 1). The Charcoal Filter will slide easily

into place, but make sure it is pushed all the way down.

Important: Rinse the Charcoal Filter thoroughly under
cool water before placing in the Pet Fountain. This will
remove any loose charcoal dust, which is harmless. A small
amount of charcoal dust may be released for the life of the
Charcoal Filter. This is normal and not harmful to your pet.
5. Fill the Pet Fountain with water. This includes the Bowl and the Housing. This will prime

the Pump.

6. Replace the Housing Lid and snap it into place.
7. Place Pet Fountain in desired location. Do not pick up a full Pet Fountain by the

Housing.

Important: To protect your floor always use a protective mat such as a

towel or water-resistant placemat. This will help protect your floor from splashing or
spills caused by your pet.

8. Before you plug in the Pet Fountain, make sure the electrical Power Cord, the plug and

your hands are dry. Plug the Pet Fountain into a standard electrical wall outlet.

9. Set the desired flow rate with the Flow Control Knob, which is located to the right of

the receiving ramp. When the Flow Control Knob is in
the 10 o’clock position, flow is at its lowest. When the
Flow Control Knob is in the 2 o’clock position, flow is
at its highest (

Fig. 2).

10. Add water as needed to the Bowl and Reservoir. Do

not let the water level fall lower than the Flow Control
Knob or you may risk Pump failure. Replacement
Pumps are sold separately by contacting the Customer
Care Centre. Visit www.petsafe.net for a telephone
listing of the Customer Care Centre near you.

Fig. 1

Fig. 2

MIN

MAX

.

Advertising