Vitek VT-3535 - Инструкция (Страница 6)

SETUP
Automatic Learn Function:
1. Learn function executes automatically and runs for approximately 3 min-
utes when batteries are first installed in the receiver.
2. Within these 3 minutes, receiver picks up the temperature & humidity sig-
nals from remote transmitter and displays the readings.
Manual-Learn (Searching for Remote Signals):
If a new remote transmitter is added or if signal is lost (outdoor display blink-
ing), learn function must be executed again.
1. Press & hold ALRAM/(AM/PM)/(C/F) for 3 seconds to start.
2. Beep sound indicates that learn function has started.
3. 'Channel' symbol will flash and unit will beep as each transmitter is
detected.
4. Temperature & humidity readings of remote transmitter displays on the
receiver.
• Press & hold Channel for 3 seconds to start
auto channel scroll function. In this mode,
the display will scroll through the data from
all the valid channels, each of which will be
shown for 8 seconds.
• Press & hold Channel for 3 seconds again
to disable this function.
ENGLISH
5
3535.qxd 31.08.2004 10:01 Page 5