WORX Tools WU724.1 - Инструкция (Страница 9)

Angle Grinder ENG
18. USE OUTDOOR EXTENSION LEADS
When the tool is used outdoors, use only
extension cords approved for outdoor
use.
19. STAY ALERT
Watch what you are doing. Use common
sense. Do not operate the tool when you
are tired or under the influence of drugs or
alcohol.
20. CHECK DAMAGED PARTS
Before further use of the tool, a guard
or other part that is damaged should be
carefully checked to determine that it will
operate properly and perform its intended
function. Check for alignment of moving
parts, free running of moving parts,
breakage of part, mounting and any other
conditions that may affect its operation. A
guard or other part that is damaged should
be properly repaired or replaced by an
authorized service center unless otherwise
indicated in this instruction manual.
Have defective switches replaced by an
authorized service facility. Do not use the
tool if the switch does not turn it on or off.
21. WARNING
The use of any accessories or
attachments, except those recommended
in this instruction manual, may present a
risk of personal injury.
22. HAVE YOUR TOOL REPAIRED BY A
QUALIFIED PERSON
This electric tool is manufactured in
accordance with the relevant safety
requirements. Repairs should only be
carried out by qualified persons using
genuine spare parts, otherwise this may
result in considerable danger to the user.
ADDITIONAL SAFETY
POINTS FOR YOUR
ANGLE GRINDER
1. Remove the plug from the socket before
carrying out any adjustment,servicing or
maintenance.
2. Fully unwind cable drum extensions to void
potential overheating.
3. When an extension cable is required you
must ensure it has the correct ampere rating
for your power tool and is in a safe electrical
condition.
4. Ensure your mains supply voltage is the
same as your tool ‘s rating plate voltage.
5. Your tool is double insulated for additional
protection against possible electrical
insulation failure within the tool.
6. Always check walls, floors and ceilings to
void hidden power cables and pipes.
7. After long working periods external metal
parts and accessories could be hot.
8. Ensure your angle grinder is switched off
before inserting the mains plug.
9. Only use your angle grinder for dry grinding/
cutting.
10. Ensure all electric cables can not contact
your angle grinder rotating disc.
11. Never stop a disc or accessory by applying
side load.
12. Never cut with grinding disc or grind with a
cutting disc.
13. Do not use cutting off wheel for side
grinding.
14. Check that speed marked on the wheel is
equal to or greater than the rated speed of
the grinder.
15. Ensure that the wheel dimensions are
compatible with the grinder.
16. Abrasive wheels shall be stored and handled
with care in accordance with manufacturer‘s
instruction.
17. Inspect the grinding wheel before use, do not
use chipped, cracked or otherwise defective
products.
18. Ensure that mounted wheels and points are
fitted in accordance with the manufacturer ‘s
instructions.
19. Ensure that blotters reused when they are
provided with the bonded abrasive product
and when they are required.
20. Ensure that the abrasive product is correctly
mounted and tightened before use and
run the tool at no-load for 30 seconds in a
safe position, stop immediately if there is
considerable vibration or if other defects are
detected. If this condition occurs, check the
machine to determine the cause.
21.In case of cup-wheels, cones or plugs with
threaded hole intended to be mounted on
the machine spindle, critical dimensions and
other data shall be given in order to prevent
the spindle end from touching the bottom of
the hole of the abrasive product.
22. If a guard is supplied with the tool never use
the tool without such a guard.
23.Do not use separate reducing bushings
09 08
RU-WU701 WU701.1 WU705 WU705.1 WU724 WU724.1-M-060726.indd 9 2006-7-26 14:13:37