WORX Tools WU641 - Инструкция (Страница 9)

Finishing Sander ENG
09 08
changing accessories, or storing power
tools. Such preventative safety measures
reduce the risk of starting the power tool
accidentally.
d) Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for
misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tools operation.
If damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
g) Use the power tool, accessories and
tool bits etc., in accordance with
these instructions and in the manner
intended for the particular type of
power tool, taking into account the
working conditions and the work to
be performed. Use of the power tool for
operations different from intended could
result in a hazardous situation.
5. SERVICE
a) Have your power tool serviced by
a qualified repairperson using only
genuine replacement parts. This will
ensure that the safety of the power tool is
maintained.
6. SPECIFIC SAFETY RULES
a) Always wear safety glasses or eye
shields when using the sander.
Everyday eyeglasses have only impact-
resistant lenses; they are NOT safety
glasses. Following this rule will reduce the
risk of serious personal injury.
b) Always wear a face mask or dust mask.
Following this rule will reduce the risk of
serious personal injury.
c) Always wear hearing protection
during extended periods of operation.
Following this rule will reduce the risk of
serious personal injury.
ADDITIONAL SAFETY
POINTS FOR YOUR
FINISHING SANDER
1. Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
2. Fully unwind cable drum extensions to
avoid potential overheating.
3. When an extension cable is required you
must ensure it has the correct ampere
rating for your power tool and is in a safe
electrical condition.
4. Ensure your mains supply voltage is same
as indicated on the rating plate.
5. Your tool is double insulated for additional
protection against a possible electrical
insulation failure within the tool.
6. Always check walls, floors and ceilings to
avoid hidden power cables and pipes.
7. After long working periods external metal
parts and accessories could be hot.
8. Wear eye protection when operating this
tool.
9. If possible, ensure the workpiece is firmly
clamped to prevent movement.
10. Your finishing sander is a hand held tool,
do not clamp your finishing sander.
11. Before sanding, check the area is free of
nails, screws, etc.
12. Never stop the finishing sander by applying
a force to the baseplate.
13. Only use paper in good condition. Do not
use torn or worn paper.
14. Do not sand material containing asbestos
due to a health risk.
15. Do not sand lead based paint due to the
risk of lead poisoning.
16. Do not eat or drink in the working area of
the sander.
17. Do not allow people to enter the working
area without wearing a dust mask.
18. Where possible, seal off the working area
to contain the dust for later removal.
19. Always wear a dust mask.
20. Your tool is designed for dry sanding only,
RU-WU641-M-060818.indd 9 2006-8-18 13:54:41