Finishing sander eng, Symbols operating instructions – Инструкция по эксплуатации WORX Tools WU641
Страница 10
Finishing Sander
ENG
not wet sanding.
21. Your tool is designed for general purpose
light polishing of wood and metals.
22. Do not sand magnesium material due to
the risk of fire.
Warning: Some dust particles created
by power sanding, sawing, grinding,
drill and other construction jobs contain
chemicals known to cause cancer, birth
defects or other reproductive harm. Some
examples of these chemicals are:
Lead from lead-based paints.
Crystalline silica from bricks and cement and
other masonry products.
Arsenic and chromium from chemically
treated lumber.
Your risk from these exposures varies,
depending upon how often you do this type of
work:
To reduce your exposure to these chemicals:
Work in a well-ventilated area.
Work with approved safety equipment, such
as those dust masks that are specially designed
to bag microscopic particles.
SYMBOLS
OPERATING INSTRUCTIONS
1. ON /OFF SWITCH
Depress to start and release to stop your tool.
2. SWITCH LOCK-ON BUTTON
Depress on/off switch (1) then lock-on button
(2)(See A), release on/off switch first and lock-
on button second. Your switch is now locked on
for continuous use. To switch off your sander
just depress and release the on/off switch.
3.VARIABLE SPEED CONTROL DIAL
Adjust the dial(3) to increase or decrease the
speed according to the material and sanding
sheet specification to be used (also possible
during no load operation)(See A). See the table
below for general guidance on speed selection.
Avoid prolonged use at very low speed as this
may damage your sander’s motor.
Sanding work
Grain
Speed
setting(opm)
Coarse
sanding
Precision
sanding
Sanding down varnishes
180
400
8700~11000
Stipping paint
40
120
9800~11000
Touching up paintwork
120
120
7600~10000
Sanding wood
60
240
7600~11000
Machining vener
180
400
8700~11000
Sanding aluminium
80
240
7600~11000
Derusting metal
40
120
9800~11000
Sanding metal and steel
120
240
9800~11000
Sanding plexiglass
180
400
6500~8700
4. HAND GRIP AREA
You can operate your sander with two hands
(See B).
5. CHANGING STANDARD SANDING
PAPER
To remove the sanding paper, lift up the clamp
lever and move away from the clamp lever
lock (See C.1). The sanding paper clamp is
now loose. Repeat with the other clamp on the
opposite side of your sander. To fit new sanding
paper, insert approximately 5mm of one end
of the sanding paper under the sanding paper
clamp until the paper contacts the housing
wall (See C.2). Lift up the clamp lever and
11
10
Read the manual
Warning
Double insulation
Wear eye protection
Wear hearing protection
Wear dust mask
RU-WU641-M-060818.indd 10
2006-8-18 13:54:43