English – Инструкция по эксплуатации Vitek VT-3543
Страница 6
ENGLISH
6
ALARM 1 setting
In the ALARM 1 Display,
=
Press MODE for about seconds: the hour digits are blinking and can be set by pressing UP or
DOWN key.
=
Press MODE again: the minute digits are blinking and can be set by pressing UP or DOWN key.
=
Press MODE again, the Alarm time is set and
icon will turn on.
ALARM 2 setting
In the ALARM Display,
=
Press MODE for about seconds: the hour digits are blinking and can set by pressing UP or
DOWN key.
=
Press MODE again: the minute digits are blinking and can be set by pressing UP or DOWN key.
=
Press MODE again, the Alarm time is set and
icon will turn on.
USING THE ALARM AND SNOOZE FOR DAILY ALARM 1 or ALARM 2
• Press the MODE button to turn the alarm 1 on, or the alarm 1 off/ the alarm on, or
the alarm off.
• When the current time reaches the alarm time that is enabled, the corresponding
alarm is activated.
• Press the MODE button when the alarm is activated will stop the alarm for 4
hours.
• When the alarm is activated, press the SNOOZE/LIGHT button and the alarm stops
but sounds again after the snooze period (4 minutes snooze period is pre-pro-
grammed).
• The repeat alarm indicator will flash.
• The alarm will stop after 4 minutes if the MODE button or SNOOZE/LIGHT button is
not pressed.
TO LIGHT THE CLOCK
Press the SNOOZE/LIGHT button to light up the clock for seconds.
LOW BATTERY LEVEL DETECTION
Should the battery capacity drop to a level that is not sufficient to operate the clock, the
low battery indicator will light up. The battery should be replaced as soon as possible
Specifications subject to change without prior notice.
3543IM_new.indd 6
15.07.2008 17:21:22