VARTA V-CDR301US - Инструкция (Страница 5)

5 www.varta-electronics.ru
Instruction manual
timer
• Press TIMER button on the RC. The
display will show SELECT SOURCES. Press
FUNCTION button to select the sound source
active when the timer activates. Press TIMER
button to confirm.
Disc, USB or memory card can be se-
lected as timer source only if corresponding
storage is connected to the unit.
• The display will show VOL with volume
level digits blinking. Set the default volume
level active when the timer activates. Press
TIMER button to confirm.
• The display will show SET ON TIMER.
Press TIMER button, then press / but-
tons to set hours. Press TIMER button to con-
firm. Press
/ buttons to set minutes.
Press TIMER button to confirm. The timer will
be activated when the set time comes.
• The display will show SET OFF TIMER.
Press TIMER button, then press / but-
tons to set hours. Press TIMER button to con-
firm. Press
/ buttons to set minutes.
Press TIMER button to confirm. The unit will
turn off when the set off-timer time comes.
The display will show clock icon.
• To cancel the timer settings press TIM-
ER button after all setting is done. The clock
icon will disappear from the display.
Sleep function
• When the unit is in operation, press
SLEEP button on the RC repeatedly to select
a period of time before the unit turns off au-
tomatically (from 10 to 90 minutes). Press the
button repeatedly to select OFF if you want to
cancel sleep function.
• When the sleep time is set, you can
press SLEEP button once to check the re-
maining sleep time.
RADIO OPERAtIOn
• Press FUNCTION button repeatedly
to select Tuner mode. The display will show
TUNER.
• Press DELETE/BAND button to switch
between FM and MW (AM).
• Press / buttons repeatedly to ad-
just the frequency step by step.
• Press and hold / buttons to start
automatic search of the nearest available sta-
tion.
• When a station is found, press MEMORY/
CLOCK button, then press FOLDER PRESET
UP/DOWN buttons to select the number of
the program. You can save 30 FM programs
and 10 MW (AM) programs.
• To select a program, press FOLDER
PRESET UP/DOWN buttons or press num-
ber buttons to input the program numbers
directly.
• Press ST/MO button on the RC to switch
between stereo and mono reception modes.
• For FM reception, adjust the telescopic
antenna appropriately to obtain the best recep-
tion on the band selected.
• The AM signal is picked up through the
built-in antenna. The set should be placed to
a position for the best reception.
CD/MP3/USB/SD OPERAtIOn
Insertion and removal of discs
• Press on the CD compartment door
in the place where OPEN/CLOSE is written.
Place a CD into the compartment with the la-
bel-side (printed side of disc) facing upwards.
Press down in the center part of disc until the
disc locks onto the center spindle.
• When the CD has been placed onto
the center spindle, gently lower the CD-door
downwards until it locks shut. The CD is now
ready to be played.
• To remove a disc, follow the same pro-
cedure as described above, except to remove
the CD instead of inserting it into the com-
partment, by placing one finger at the middle
of disc (center spindle) and the other at the
edge of the disc and gently pulling upwards.
Always hold a CD by its edges. Avoid
getting any finger prints, smudges or dirt onto
the surface of a disc. In case this happens,
use a special CD-cleaning cloth or cleaning kit
to remove the dirt or smudges. Please make
sure to always fold down the handle before
opening the CD door.