Petsafe Staywell Deluxe - Инструкция (Страница 40)

40 www.petsafe.net
FI
SV
DA
NO
RU
EN
b) In Glass
* It is not possible to cut holes in toughened glass or double glazed
units except at the time of manufacture. Please consult a glazier.
The cat flap requires a circular cut-out with a diameter of 212 mm
(8 3 /
8
”) (Fig. 4).
Not to scale - for best results you should refer
your glazier to the enclosed cutting template.
c) In Walls
Follow the instructions for “Wood and PVC/uPVC/Metal”, by using the
enclosed cutting template. Please note that additional tools, materials and
competent DIY skills may be required.
Fitting your cat flap
Your PetSafe ® cat flap is fitted with the red 4-way lock on the
inside of your house.
Temporarily place the cat flap in the hole and position the outside cover
on the outside of the house. From the outside mark screw holes on the
door through the holes in the outside cover (Fig 5).
Remove the cat flap and drill the holes with a 5 mm ( 3 /
16
”) drill
bit (Fig. 6).
FIG.5 FIG.6
Replace the cat flap in the hole and
from the outside screw into place (Fig. 7).
If the screws are too long they may need to be cut down to match the
depth of your door. Using over long screws may damage the cat flap.
The screws should be removed from the cat flap before cutting. File down
to ensure there are no sharp edges.
Push fit the 4-way locking turning dial into place (Fig. 7).
Finally, cover the screw holes with the blanking plugs on the outside
frame to ensure a neat finish (Fig. 7).
FIG.4
Glass windows & doors, single and double glazed*
212 mm (8 3 /
8
”)
Fits brick walls