Petsafe Staywell Deluxe - Инструкция (Страница 39)

39
EN
RU
NO
DA
SV
FI
Replacement flaps available online
Before installing your cat flap
please read the following step-by-
step instructions carefully.
Tools required
• Pencil
• Ruler
• Jig or Keyhole Saw
• Drill
• 5 mm ( 3 /
16
”) drill bit
• Screwdriver
• Tape measure
• Glue
• Sand paper
Measurement and marking
Measure the belly height of your cat. This is usually 100 mm to150 mm
(4” to 6”) (Fig. 1).
Mark this measurement on the outside of your door and draw a straight
horizontal line 168 mm (6 1 /
2
”) (Fig. 2).
Please bear in mind that this line will eventually be the bottom of the
hole you will cut in your door and that the frame of the cat flap will be
slightly lower. If necessary, this line may have to be raised slightly to
account for this.
FIG.1 FIG.2
Cutting a hole for your cat flap
a) In Wood and PVC/uPVC/Metal
The cat flap requires a square cut-out of 175 mm x 168 mm
(6 3 /
4
” x 6 1 /
2
”) (Fig. 3).
Not to scale - for best results you should refer
to the enclosed cutting template.
(x)
(x)
175 mm
(6 3 /
4
”)
FIG.3 168 mm (6 1 /
2
”)
Wooden doors
PVC/uPVC/Metal