MAXWELL MW-3801 W - Инструкция (Страница 13)

13
eNGliSH
Baking 1:15
«keep warm» button (33)
After the cooking ends the unit switches to the keep warm mode automatically. You can activate the
keep warm function by yourself. Press the button (31) once, the indicator (20) will light up. To stop the
warm keeping press «Start/Stop» button (25) repeatedly, the indicator (20) will go out.
Note: Do not use the keep warm function for heating up the products.
“Hours” (21) and “Minutes” (23) buttons
Use buttons (21) and (23) to set time (current time) of cooking in “Bouillon”, “Soup”, “Steam” and
“Stew” programs.
BeFore uSiNG tHe uNit For tHe FirSt tiMe
1. Unpack the unit, remove any stickers and package materials that can prevent normal operation
of the unit.
2. Place the unit on the flat, dry, heat-resistant surface away from water, moisture and open flame.
Distance to the nearest surfaces should be at least 20 cm.
Attention! Do not use the unit near bath tubs, kitchen sinks or other containers filled with
water.
Note: In case of unit transportation or storage at low temperature it is necessary to keep it for at least
two hours at room temperature before switching on.
3. Remove the steam release lid (6) pulling it upwards.
4. Open the multicooker lid (5) by pressing the button (4).
5. Remove the protection screen (13) by pressing the clamps (14).
6. Wash all the removable details (protection screen (13), steam release lid (6), bowl (12), tray for
steam cooking (15), soup ladle (16), spatula (17) and measuring cup (18)) with a soft sponge with
neutral detergent, then rinse and dry.
7. Wipe the unit body with a damp cloth. Let the unit dry.
8. Install protection screen (13) back to its place.
9. Install steam release lid (6) back to its place.
current time setting
1. Connect the power cord to the jack (9).
2. Insert the plug into the socket, there will be a sound signal and the operation indicator (24) will
flash.
3. Press and hold the «Hours» (21) or «Minutes» (23) button for about 3 seconds, there will be a short
sound signal.
4. Then set the current time (24 Hr) by pressing or holding the «Hours» (21) and «Minutes» (23) but-
tons.
5. To finish the setting press any button on the control panel (3).
uSiNG oF tHe Multicooker
1. Load the ingredients in the bowl following the recipe (see «Recipe book»).
Note: Make sure that the products and liquids level don’t exceed the maximal mark. The
maximal mark for porridges (except for rice) – 3/4, maximal mark for other products and
liquids – “CUP”.
mw-3801.indd 13 22.05.2012 14:20:59