Philips FC8952 - Инструкция (Страница 12)

Troubleshooting
This chapter summarises the most common problems you could encounter with the appliance.
If you are unable to solve the problem with the information below, visit www.philips.com/support
for a list of frequently asked questions or contact the Consumer Care Centre in your country.
1 The suction power is insufficient.
- Perhaps the dust bucket is full.
If necessary, empty the dust bucket.
- Perhaps the dust bucket lid is not placed correctly.
Place the lid correctly.
- Perhaps the filters need to be cleaned or replaced.
If necessary, clean or replace the filters.
- Perhaps the nozzle, tube or hose is blocked up (Fig. 48).
To remove the obstruction, disconnect the blocked-up part (hose or tube) and connect it (as well
as possible) the other way round. Switch on the vacuum cleaner to force the air through the
blocked-up part in opposite direction.
2 The sound produced by the vacuum cleaner suddenly changes while I am vacuuming.
- Perhaps the vacuum cleaner picked up a foreign object that is tumbling around in the dust
bucket. Empty the dust bucket.
3 The amount of water in the dust bucket is below the minimum level indication.
- The performance of the vacuum cleaner is not optimal. Fill the dust bucket with water. Make
sure the water level is between the minimum and maximum level.
4 The amount of water in the dust bucket exceeds the maximum level indication.
- Empty the dust bucket until the water level is below the maximum level.
5 I used the vacuum cleaner to pick up water or other liquids.
- The appliance is not suitable for picking up water or liquids. Make sure the water level does not
exceed the maximum level in the dust bucket (see point 4).
6 Water leaks out of the appliance.
- Perhaps you tilted the appliance too much. This can cause water leakage. Keep the vacuum
cleaner flat on the ground.
7 Foam develops inside the dust bucket while using the vacuum cleaner.
- If you add soap or perfume to the water, make sure that this is non-foaming soap or perfume.
- If foam develops inside the dust bucket, stop vacuum cleaning. Empty the dust bucket and fill it
with fresh water.
8 FC8952 only: hairs are entangled around the brush inside the mini turbo brush.
- Clean the mini turbo brush. See chapter ‘Cleaning’, section ‘Cleaning the mini turbo brush’.
English 12