ZELMER 28Z017 - Инструкция (Страница 53)

53
Move the – Steam Control Knob (7) to selected position, in order to set
the amount of steam.
After finishing move the – Temperature Dial
(2) in anti-clockwise direction to „MIN”; the
iron is switched off.
Move the – Steam Control Knob (7) to
position.
Disconnect the iron from mains supply –
outlet.
When the iron gets cool completely, store it –
vertically in a safe place.
Burst of steam – Always follow the garment manufacturer’s
ironing instructions mentioned at the garment label.
This function provides extra amount of steam to remove stubborn wrinkles
at clothes and hanging garments.
Unwind and straighten the power cord. –
Fill the water tank with demineralised water or distilled water. (See –
How To Fill Water)”.
Connect the iron to a suitable mains supply outlet. –
Move the – Steam Control Knob (7) to selected position, in order to set
the amount of steam.
Turn the – Temperature Dial (2) in clockwise direction to position.
See the item „Preparation for operation”.
Control light (4) – glows, indicating that the iron is on.
Control light goes off when the required temperature is reached. The –
iron is now ready for use.
Press the – Burst of Steam Button (9) once – steam will shoot from the
holes of the soleplate.
For stubborn wrinkles, wait a few seconds before pressing the – Burst
of Steam Button (9) again. Most wrinkles can be removed within
three presses.
After finishing move the – Temperature Dial (2) in anti-clockwise
direction to „ MIN”; the iron is switched off.
Move the – Steam Control Knob (7) to position.
Disconnect the iron from mains supply outlet. –
When the iron gets cool completely, store it vertically in a safe place. –
ATTENTION:
It may be necessary to press the burst
of steam button a few times to start this
function.
For optimum steam quality, do not operate
the Burst Of Steam more than three times
after the pilot light goes off.
Burst of steam in vertical position – Always follow the garment
manufacturer’s ironing instructions mentioned at the garment label.
This function provides extra amount of steam to remove wrinkles on
delicate garments in hanging position, hanging curtains, or other hanging
fabrics.
Warning:
Do not apply steam on any clothes or fabrics that are being worn by
human or pets. Temperature of steam is very high.
Fill the water tank with demineralised water, or distilled water. (See –
How To Fill Water)”.
Connect the iron to a suitable mains supply outlet (See the item –
„Preparation for operation”).
Move the – Steam Control Knob (7) to selected position, in order to set
the amount of steam.
Turn the – Temperature Dial (2) in clockwise direction to position.
See the item „Preparation for operation”.
Control light (4) – glows, indicating that the iron is on.
Control light goes off when the required temperature is reached. The –
iron is now ready for use.
Hold the iron between 15 and 30 centimetres away from the garment. –
Press the – Burst of Steam Button (9) once – steam will shoot from the
holes of the soleplate.
For stubborn wrinkles, wait a few seconds before pressing the – Burst
of Steam Button (9) again. Most wrinkles can be removed within
three presses.
After finishing move the – Temperature Dial (2) in anti-clockwise
direction to „ MIN”; the iron is switched off.