Candy GOY 1054 L - Инструкция (Страница 51)

51
To reactivate the spin cycle is enough to press the button until you reach the spin speed
you would like to set.
For not damage the fabrics, it is not possible to increase the speed over that auto-
matically suitable during the selection of the program.
It is possible to modify the spin speed in any moment, also without pause the machine.
NOTE: The machine is fitted with a special electronic device, which prevents the
spin cycle should the load be unbalanced. This reduces the noise and vibration in
the machine and so prolongs the life of your machine.
“Degree of soiling” button
E
By selecting this button (active only on COTTON and MIXED FIBRES programs) there is a
choice of 3 levels of wash intensity, depending on how much the fabrics are soiled.
Once the program has been selected the indicator light will automatically show the mini-
mum level required for that program. Pressing the button increases the duration of the
wash cycle, and adjusts the wash settings accordingly. For example: Using this button on
the Rapid Wash cycle will enable you to select either a 14, 30 or 44 minute wash cycle.
"Start delay" button
F
This button allows you to preprogram the wash cycle to delay the start of the cycle
for up to 24 hours.
To delay the start use the following procedure:
 Set the required program;
 Press the button once to activate it (h00 appears on the display) and then press it again
to set a 1 hour delay (h01 appears on the display). The pre-set delay increases by 1 hour
each time the button is pressed, until h24 appears on the display, at which point pressing
the button again will reset the delay start to zero.
Confirm by pressing the “START/PAUSE” button (the light on the display starts to flash).
The countdown will begin and when it has finished the program will start automatically.
It is possible to cancel the delay start by taking the following action:
 Press and hold the button for 5 seconds until the display will show the settings for the
program selected.
 At this stage it is possible to start the program previously selected by pressing the
“START/PAUSE” button or to cancel the process by setting the selector to the OFF posi-
tion and then selecting another program.