Whirlpool AWG 2311 - Инструкция (Страница 25)

ADJUSTMENT OF FEET
•
Do not install your machine on rugs or similar surfaces.
•
For your machine to work silently and without vibrations, it should be
settled on a flat, non-slippery and tough surface.
•
You can adjust the balance of your machine from its feet.
•
First, loosen the plastic adjustment nut.
•
Adjust by rotating the feet upwards or downwards.
•
After balance has been achieved, tighten the plastic adjustment nut
again by rotating it upwards.
•
Never put cartons, wooden blocks or similar materials under the
machine to adjust the levelness of the machine with the ground.
ELECTRICAL CONNECTION
•
Your washing machine works with 220-240V and 50Hz.
•
A special grounded plug has been attached to the network cable of
your washing machine. This plug must be inserted to a grounded 10
amp socket. The currency rating of the attached electricity supply
should also be 10 amps. If you have no such sockets and fuses in
your house, the plug should be fitted by a qualified electrician.
•
Our company will not be held liable for any damage that may
occur as a result of usage without grounding.
WATER SUPPLY CONNECTION
•
Depending on the specifications of your machine, it may be provided
with a single water inlet (cold) or double water inlet (cold/hot). The
white headed hose is for the cold water inlet and red headed hose is
for the hot water inlet (for machines with hot & cold water inlet).
•
To prevent leakage from the connection joints, 1 (valid for cold water
inlet) or 2 (valid for machines with hot & cold water inlet) seals are
included in the hose packaging. Fit these seals at the end of water
inlet hoses on the tap side.
•
Connect the white headed hose to the water inlet valve with white
filter and connect the red headed hose to the water inlet valve with
red filter (latter in the case of machines with hot & cold water inlet).
Manually tighten the connection parts. Please call a qualified plumber
for safer connections.
23