Whirlpool AWG 2311 - Инструкция (Страница 24)

•
As a result of quality control procedures, a certain amount of water
may remain in your machine. This is not harmful for your machine.
INSTALLATION
You must pay close attention to the following issues before using your
washing machine.
REMOVAL OF TRANSPORTATION SCREWS
•
Transportation screws, which are located at the rear side of the
machine, must be removed before running the machine.
•
Loosen the screws by rotating counter clockwise using a suitable
wrench. (DIAGRAM-1)
•
Remove the screws by pulling them.(DIAGRAM-2)
•
This will cause the plastic parts located in the interior part of your
machine to drop down under the appliance.
•
Lift the machine up slightly to pick up the plastic parts.
•
If all of the plastic parts from the screw groups have not dropped
down, open the door of your machine, move the drum until all plastic
parts drop down. Collect the parts that have fallen to the floor.
•
In the holes where the transport screws have been removed, insert
the plastic transport screw taps found in the accessories bag.
(DIAGRAM-3)
•
The transportation screws that have been removed from the machine
should be kept safe in the event of future transportation.
DIAGRAM-2
DIAGRAM-1 DIAGRAM-3
22