Elenberg RF-0925 - Инструкция (Страница 13)

1
Before uSIng your refrIgerator
• Remove the exterior and interior packing.
• Check to be sure you have all of the following parts:
1 ice Cube Tray
2 Shelves
1 Crisper Cover
1 Crisper
1 Water Drip Tray
1 instruction Manual
• Before connecting the refrigerator to the power source, let it stand upright
for approximately 2 hours. This will reduce the possibility of a malfunction in
the cooling system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
InStallatIon of your refrIgerator
• Place your refrigerator on a floor that is strong enough to support the refrig-
erator when it is fully loaded. To level your refrigerator, adjust the legs at the
front of the refrigerator.
• Allow 5 inches of space between the back and sides of the refrigerator, which
allows the proper air circulation to cool the compressor.
• Locate the refrigerator away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating and heat
sources may increase electrical consumption. extreme cold ambient tem-
peratures may also cause the refrigerator not to perform properly.
• Avoid locating the refrigerator in moist areas. Too much moisture in the air
will cause frost to form quickly on the evaporator requiring more frequent
defrosting of the refrigerator.
• Plug the refrigerator into an exclusive properly installed-grounded wall out-
let. Do not under any circumstances cut or remove the third (ground) prong
from the power cord. Any questions concerning power and or grounding
should be directed toward a certified electrician.
electrIcal connectIon
Warning:
Improper use of the grounded plug can result in the risk of electrical shock.
If the power cord is damaged, It must be replaced by the manufacturer, its
service agent or similarly qualified persons in order to avoid a hazard.
• This unit should be properly grounded for your safety. The power cord of this
refrigerator is equipped with a three-prong plug which mates with standard
three prong wall outlets to minimize the possibility of electrical shock.
• Do not under any circumstances cut or remove the third ground prong from
the power cord supplied.
• Use of extension cords is not recommended.
• This refrigerator requires a standard 220/240 volt, 50 hz electrical outlet
with three-prong ground.
• The cord should be secured behind the refrigerator and not left exposed or
dangling to prevent accidental injury.
reverSIng the door of your refrIgerator
This refrigerator can be opened either from the left or right side. The default
way of opening the door is from the right side. if you want to open the door
InStallatIon InStructIonS