Flowserve MX Limitorque - Инструкция (Страница 75)

75
Limitorque MX Electronic Actuator FCD LMRUIM2306-00 – 1/11
flowserve.com
Рисунок 4.29 – Пользовательская настройка управления
CHANGE INPUTS
CHANGE S
TA
TUS
INPUT (0)?
ST
ATUS
(OFF)?
INPUT (1) INPUT (2)
(CLOSE INHIBIT) (OPEN INHIBIT) (BOTH INHIBIT) (USER INHIBIT) (CSE)-SEE NOTE
1
(CLOSE) (OPEN) (STOP) (POSITION)
(ABSENT)
(ON)
see Note
2
see Note
4
see Note
3
see Note 5
see Note
6
ST
ATUS FUNCTION
ESD?
ESD ACTION (IGNORE)-OK?
ESD MOVE TO XXX% OPEN
SIGNAL
(PRESENT)-OK?
Note 1: Only input 2 will display “CSE” as an option. The user must run the “remote” indication signal of the CSE to inout 2, and define input 2, status function as CSE for it to work with Fieldbus/Profibus. If CSE option is chosen for input 2, they will only be able to select “SIGNAL PRESENT”. Note 2: The “ESD ACTION” menu will only appear if the user selects the “ESD” status function for the input. Other
wise the “SIGNAL PRESENT” menu will return the “CHANGE INPUTS” menu.
Note 3: “ESD MOVE TO” menu only appears if Position is chosen as action. The following menus will appear if the customer has the custom mode input option, and has enabled custom mode 1 (in remote cont
rol menu).
Note 4: The “ESD ACTION” menu will only appear if the status function for the input is “MOMENT
AR
Y ESD/PSESD”.
Other
wise the “SIGNAL PRESENT” menu will return to the “CHANGE INPUTS” menu.
Note 5: The “ESD MOVE TO” menu only appears if position is chosen as action
.
Note 6: “PS MOVE TO” menu only appears if the status function of the input is “MOMENT
AR
Y ESD/PSESD”.
The user will only be able to change the ESD ACTION (and ESD MOVE TO target if ESD action is position, and the PS MOVE TO setti
ngs when in this special custom mode 1.
Following are the preconfigured settings for each input. Input 0: off, user input, signal present Input 1: off, psesd enable, signal present Input 3: on, momentar
y esd release, signal present
Input 4, on, momentar
y esd release, signal present
Input 5: on, momentar
y esd/psesd. signal present, esd action close, ps move to target 0%
CHANGE INPUTS
CHANGE S
TA
TUS
INPUT (0)?
ST
ATUS
(OFF)?
INPUT (1) INPUT (2) INPUT (3) INPUT (4) INPUT (5)
(PSESD ENABLE) (M
OM
EN
TA
RY
ESD RELEASE)
(M
OM
EN
TA
RY
ESD/PSESD)
(CLOSE) (OPEN) (STOP) (POSITION)
(ABSENT)
(ON)
ST
ATUS FUNCTION USER INPUT?
ESD ACTION (IGNORE)-OK?
PS MOVE TO
O% OPEN
ESD MOVE TO XXX% OPEN
SIGNAL
(PRESENT)-OK?
YES
NO
NO YES NO
YES NO
YES NO
YES NO
YES NO
YES NO
YES NO
YES NO
YES
NO YES
NO YES
NO YES
NO YES
NO
YES