Removing the unit, Specifications, Removing the unit specifications – Инструкция по эксплуатации Sony CDX-R33EE

Страница 13

Advertising
background image

13

Cleaning the connectors

The unit may not function properly if the
connectors between the unit and the front panel
are not clean. In order to prevent this, detach the
front panel (page 4) and clean the connectors
with a cotton swab dipped in alcohol. Do not
apply too much force. Otherwise, the connectors
may be damaged.

Notes
For safety, turn off the ignition before cleaning the

connectors, and remove the key from the ignition
switch.

Never touch the connectors directly with your fingers

or with any metal device.

Removing the unit

1

Remove the protection collar.

1

Detach the front panel (page 4).

2

Engage the release keys together with the
protection collar.

3

Pull out the release keys to remove the
protection collar.

2

Remove the unit.

1

Insert both release keys simultaneously
until they click.

2

Pull the release keys to unseat the unit.

3

Slide the unit out of the mounting.

Specifications

CD Player section

Signal-to-noise ratio: 120 dB
Frequency response: 10 – 20,000 Hz
Wow and flutter: Below measurable limit

Tuner section

FM

Tuning range:

FM1/FM2: 87.5 – 108.0 MHz (at 50 kHz step)
FM3: 65 – 74 MHz (at 30 kHz step)

Aerial terminal: External aerial connector
Intermediate frequency: 10.7 MHz/450 kHz
Usable sensitivity: 9 dBf
Selectivity: 75 dB at 400 kHz
Signal-to-noise ratio: 67 dB (stereo), 69 dB (mono)
Harmonic distortion at 1 kHz: 0.5 % (stereo),

0.3 % (mono)

Separation: 35 dB at 1 kHz
Frequency response: 30 – 15,000 Hz

AM

Tuning range:

531 – 1,602 kHz

Aerial terminal: External aerial connector
Intermediate frequency: 10.7 MHz/450 kHz
Sensitivity: 30 µV

Power amplifier section

Outputs: Speaker outputs (sure seal connectors)
Speaker impedance: 4 – 8 ohms
Maximum power output: 50 W

× 4 (at 4 ohms)

General

Outputs:

Audio outputs terminal (sub/rear switchable)
Power aerial relay control terminal
Power amplifier control terminal

Inputs:

Telephone ATT control terminal
Remote controller input terminal
Aerial input terminal

Tone controls:

Low: ±10 dB at 60 Hz (XPLOD)
Mid: ±10 dB at 1 kHz (XPLOD)
High: ±10 dB at 10 kHz (XPLOD)

Main unit

Back of the front panel

Orient the release
keys as shown.

Hook facing
inwards.

continue to next page

t

Advertising
Эта инструкция подходит к следующим моделям: