TIMBERK TCC 10 A1 - Инструкция (Страница 12)

7. CLEANING AND MAINTENANCE INSTRUMENT
Make replace the filter if the following problems:
- the flow of air from the air outlet became weaker, and the noise increased
- changed color filter, which indicates that pollution filter
Before cleaning the device, make sure that the plug is disconnected from the
outlet. Otherwise, it could lead to electric shock.
To clean the outer surface of the device, use a damp soft cloth.
To avoid electric shock, do not scratch or damage during cleaning elements
of the device.
Do not use when cleaning the device thinner, benzine, xylene, a stiff brush,
talc powder and other substances, except water.
Perform cleaning of the device once or twice a week.
Keep the instrumentina room with low humidity.
Wipe off any excess water in the reservoir grooves damp, soft cloth.
For the removal of water on small details, you can use a soft brush and then
wipe them again with a soft cloth.
S p e n d c l e a n t h e h u m i d i f i e r o n c e o r t w i c e a w e e k .
In the formation of dirt on the membrane, clean it with a soft brush.
Use a soft brush to erase the remnants of surface water spray, then wipe
again with a soft cloth.
Rinse the water tank and sprayer with clean water. Wash the lid gently and
without effort, otherwise it will lead to leakage of water through the cover.
After removing the residual water from the surface of the nozzle, wipe with a
soft cloth.
Clean the outside surface of the device and a damp, soft cloth.
8.TROUBLESHOOTING
In case of emergency contact information listed In the table below. If you can
not solve problems independently, to a service center.
Term reliability isSyears.
At the end of the life of the humidifier should be subjected to disposal in
accordance
the rules, regulations and methods, at the place of disposal.
Malfunction Causation Resolve methods
Power indicator can't
work and with no wind
and mist
Didn't connect the power
supply
Connect the humidifier from
the power supply
Didn't turn on the
humidifier Switch on the unit
Power indicator
iiluminate, the unit
with wind but no mist
No water in the water
tank
Fill water in water tank
Smeliy mist New humidifier Open water tank, put it in
shadow for 12 hours
Dirty water or iong-time
to store water in water
tank
Clean the water tank, fill clean
water in
Power indicator
iiluminate, the unit
with no wind and mist
Too much water in the
base flume
Empty the flume, then close
the cap of water tank
Little mist comes out
of the nozzle
Dirty ultrasonic
transducer
Clean the transducer
Dirty water or long-time
to store water in water
tank
Clean the water tank, fill clean
water in
Abnormai noise Caused by little water in
water tank
Fill water in water tank
Resonance from tabie-
board Place on a stable level surface
When you turn the
device does not work Ensure that the plug is inserted into the socket
Gentle air stream Filters are dirty. Change filters
Switch does not work 1. Might have a defective fuse. Contact your dealer
2. Check the power supply
A lot of noise and
vibration 1. The precarious position of the instrument
2. Uneven surface installation location
air cleaner
3. Filters are dirty. Change filters
12 www.timberk.ru • climatic complex