Vitek VT-3304 - Инструкция (Страница 5)

СПЕЦИФИКАЦИЯ
Питание
AC 230 В ~ 50 Гц;
DC 9 В UM 1(D) x 6
Частотные диапазоны FM1 64 88 МГц;
FM2 88 108 МГц;
LW 150 275 КГц;
Выходная мощность 2 Вт х 2
СРОК СЛУЖБЫ МАГНИТОЛЫ НЕ МЕНЕЕ 3 Х ЛЕТ
12
Tape Deck A will play first, then stop automatically at the end of the tape. The tape in
Deck B will then start and stop automatically at the end of the tape.
• DUBBING A CASSETTE TAPE
1. Slide the Function Switch to select the TAPE.
2. You can choose the high speed copying mode by pressing the Normal or High Speed
Dubbing button.
NOTE:
Hi Speed dubbing recording is approximately 2 times faster than normal speed. To ensure
continuous recording, do not change the dubbing speed while recording.
3. Insert a prerecorded tape into Deck A.
Insert the blank tape into Deck B.
Press the PAUSE and RECORD keys on Deck B.
4. Press PLAY on Deck A. The PAUSE on Deck B will be released automatically.
5. Press STOP to manually end recording.
• MIC RECORDING
A. Install a cassette tape.
B. Place FUNCTION SWITCH to “MIC” position.
C. Depress RECORD BUTTON and PLAY BUTTON simultaneously. Recording then starts
through the BUILT IN CONDENSER MICROPHONE.
D. To end recording, press the STOP/EJECT BUTTON or it will automatically stop when the
cassette runs to the very end.
• RADIO RECORDING
A. Install a cassette tape.
B. Place FUNCTION SWITCH to "RADIO" position. After selecting the desired band and tune
the TUNING KNOB to desired broadcast station. Then push down RECORD BUTTON and
PLAY BUTTON simultaneously.
C. After recording the desired broadcast, depress the STOP/EJECT BUTTON lightly, and then
place FUNCTION SWITCH to "TAPE" position in order to listen to the recorded broadcast.
D. If you desire to play recorded broadcast, please follow the instructions explained in play
back section.
ERASURE: When you record over previously recorded tape, the original recording is automat
ically erased and replaced by this newly recording material.
• HEADPHONE JACK
For private listening, insert a 3.5mm headphone (not included) into the HEADPHONE JACK.
The SPEAKER output is automatically cut off.
CAUTION: LISTENING AT HIGH POWER FOR ALONG MOMENT COULD DAMAGE USERS'
EARS.
• PRECAUTIONS AND MAINTENANCE
A. Avoid placing this unit near sources of high temperature such as fireplace or sunlight for
long time as this may result in damages to plastic housing or electrical parts inside the unit.
5
ENGLISH РУССКИЙ
Vt-3304.qxd 09.07.03 11:50 Page 10