Vitek VT-3452 - Инструкция (Страница 9)

9
2. Follow steps 2 and 3 in "LISTENING TO THE RADIO" to
tune in the station you wish to record.
3. Insert a blank tape to cassette compartment then close
the cassette door.
4. Press the RECORD and PLAY buttons (9) at same time to
start recording.
5. Press the STOP/EJECT button to stop recording.
Note:
1. Return to Tape mode, rewind the tape to listen to record-
ed materials.
2. Recording through built-in microphone (Tape mode):
similar to above descriptions.
3. To playback, press the PLAY button (9).
4. To stop Playback, press the STOP/EJECT button (9).
TAPE RECORDING From CD
1. Select the FUNCTION selector (1) to CD mode then open
the CD door by lift up door lid (8).
2. Put a disc inside CD compartment and then close the CD
door
3. Insert a blank tape to cassette compartment then close
the cassette door.
4. Press the RECORD and PLAY button (9).
5. Press the PLAY/PAUSE button (14) to start CD playing for
recording.
6. Press the STOP/EJECT button to stop recording and CD
playback will stop too.
CARE AND MAINTENANCE
COMPACT DISC CARE
Treat the disc carefully. Handle the disc only by its edges. Never allow your fingers to come in contact with the shiny,
unprinted side of the disc.
Do not attach adhesive tape, stickers etc., to the disc label.
Clean the disc periodically with soft, lint-free, dry cloth. Never use detergents or adhesive cleaners to clean the disc. If
necessary, use a CD cleaning kit.
If disc skips or gets stuck on a section of the disc, it is probably dirty or damaged (scratched).
When cleaning the disc, wipe in straight lines from the centre of the disc to the edge of the disc.
Never wipe in circular motions.
To remove a disc from its storage case, press down on the centre of the case and lift the disc out, holding it carefully by
the edges.
Fingerprints and dust should be carefully wiped off the disc's recorded surface with a soft cloth.
Unlike conventional records. compact disc have no grooves to collect dust and microscopic debris so gently wiping with a
soft cloth should remove most particles.
TAPE HEAD CLEANING
The tape heads, pinch roller and capstan require periodic cleaning. This removes particles of the metal oxide coating that
wear off the tape and accumulate on these parts and impair performance. Switch off the power, press the Stop/Eject Key to
open the cassette door, and press the Play Key. Clean the tape heads, pinch roller and capstan with a soft cloth or cotton
swab dampened in isopropyl alcohol or special tape head cleaner.
ENGLISH
3452.qxd 4/6/05 9:28 AM Page 9