Bork CH BRE 1818 SI - Инструкция (Страница 27)

27
Instruction manual Eng
Figure 2
1. Mode & set time button
2. Power & thermostat Knob
3. Oscillation button
Figure 3
1. Mode indicator
2. Power indicator
3. Set time indicator
4. LED display
The heater may be operated by the manual controls located on
the heater (as shown in Figure 2) or by the remote controller. The
heater working state may be known from display panel (as shown
in Figure 3).
1. Carefully remove the heater from the bag and the carton.
2. The heater must be placed on a firm, level surface.
3. Plug the cord set into a 220-240V� electrical outlet. Be sure plug
fits tightly in outlet. A loose fit will cause overheating and damage
the plug. Plug and cord set may feel warm during normal usage.
4. When the heater is initially plugged in and turn on the power switch
on the base, there will be a “beep” and the red light will come on
indicating that there is power to the unit. The red light will remain
lit until the power switch on the base is turned off.