Bork CH BRE 2018 SI - Инструкция (Страница 22)

Oscillating ceramic heater with thermostat CH BRE 2018 SI
22
OPERATION GUIDE >
1 2 3
Control panel
Control panel
1. Mode & set time button
2. Power & thermostat Knob
3. Oscillation button
The heater may be operated by the manual controls located on the
heater.
1. Carefully remove the heater from the bag and the carton.
2. The heater must be placed on a firm, level surface.
3. Plug the cord set into a 220-240V electrical outlet. Be sure plug
fits tightly in outlet. A loose fit will cause overheating and damage
the plug. Plug and cord set may feel warm during normal usage.
4. When the heater is initially plugged in and turn on the power switch
on the base, there will be a “beep” and the red light will come on
indicating that there is power to the unit. The red light will remain
lit until the power switch on the base is turned off.
5. Turn the heater on by pressing the Power & Mode button.
6. The LСD displayer on the display panel will display the current
room temperature.
7. Upon turning the heater on, the unit will be in the LOW heat mode
(1100 watts) and the LOW indicator will be displayed on LCD.
8. Pressing the Power & Mode button at this point will set the heater
into the HIGH heat mode(1800 watts) and the HIGH indicator will
be displayed on LCD.
9. Pressing the Power & Mode button at this point will set the heater
into the AUTO mode. Notice that the displayer now displays a set
temperature indicator.(see Thermostat instruction)
10. Pressing the Power & Mode button once more will set the heater
into the FAN mode (15 watts). FAN mode is for fan-only operation,
without any heat output.