Vitek VT-1126 - Инструкция (Страница 6)

7
СХЕМА И ОПИСАНИЕ ЧАЙНИКА scale may still build up on base. Descale regularly using a proprietary descaler.
CLEANING THE FILTER
Removing/Refitting the Filter:
Important: Before removing or refitting the filter, switch the kettle off, let it cool
down fully, and unplug the power base.
To remove the filter:
• Empty the kettle and open the lid.
• Take hold of the tab at the top of the filter
and pull upwards. The filter should unclip
itself from the two side clips.
To clean the filter:
• Rinse under a tap whilst brushing with a
soft brush.
To refit the filter:
• Make sure that your hands are clean and free from soap, cream or any
thing, which might taint the water.
• Holding the tab. replace the filter ensuring the tab is uppermost and fac
ing to the rear of the kettle.
• Check filter is located at lower end of spout, and into two side locations.
• Clip filter into position by pressing on top of filter at two side location
points.
SPECIFICATION
Power requirement
230 V ~ 50 Hz
Max. power 2200 W
Max indication of water 1,8 L
SERVICE LIFE OF THE KETTLE NOT LESS THAN 3 YEARS
ENGLISH
6
РУССКИЙ
1. Подставка чайника
2. Ненагреваемая ручка чайника
3. Съемный фильтр
4. Сетевой шнур
5. Индикатор работы
6. Шкала чайника
7. Кнопка “Вкл./Выкл.”
8. Кнопка, открывающая крышку
чайника
Vt-1126.qxd 11.12.03 11:18 Page 12