Vitek VT-1214 - Инструкция (Страница 4)

17
HOW TO FILL WATER
1. Disconnect the iron from mains supply
outlet.
2. Move the Steam Control/Self Cleaning
Knob to position:
3. Release the Water Inlet Cover.
4. Fill water through the water inlet hole.
(See figure 2)
4. Fill up to the 'Max' level marked on the
side of water tank.
Note:
For best result, it is advisable to use demineralised water or distilled
water. Do not use chemically descaled water or any other liquids.
HOW TO SET TEMPERATURE
1. Connect the iron to a suitable mains supply outlet.
2. The LCD light up for a second and one beep can be heard.
3. "STANDBY" will flash on the LCD.
4. To adjust the temperature settings depress the control button a beep
will be audible every time the control button is pressed.
5.The temperature setting will cycle "MAX •••(3dot) ••(2dot) •
(1dot) ……etc." and will indicate on the LCD Display:
6. The "STANDBY" will flash to indicate the iron is heating up or cooling
down. The "STANDBY" will flash at the time of ironing, this is perfectly
normal as it shows the iron maintain the heat setting you have chosen.
7. When the required temperature is reached; the "STANDBY" will be
gone and beep twice.
8. The iron is ready for use.
4
FIGURE 2
На ярлыке означает: изделие нельзя гладить!
(например, эластик)
Примечание:
вид ткани
синтетика
синтетика
ацетатволокно
триацетат
с люрексом
полиамид
(нейлон)
полиэстер
вискоза
шелк
шерсть шерсть
хлопок хлопок
лен лен
синтетика
акрил
полипропилен
полиэтан
волокно
позиция
терморегулятора ярлык
шелк
ENGLISH РУССКИЙ
1214new.qxd 03.07.03 16:51 Page 8