5 synchronisation / pairing – Инструкция по эксплуатации SIGMA BC 1009 STS
Страница 14
14
1009
Installation of the BC 1009 STS into the mounting bracket – The zero
of the speed is flashing. To synchronise the speed there are 2 options:
1
Set off, usually the receiver has paired with the transmitter within
3 or 4 wheel turns.
2
Turn front wheel until the KMH display stops flashing. Removing the
BC 1009 STS from the mounting will cut off the connection.
TOO MANy SIGNALS are shown: Extend the distance of all
transmitters and press any button to continue. Pairing begins again.
(If tranmission fails whilst cycling and no longer works, please press the MODE 1 button
for more than 3 sec. to start manual pairing. SyNCH RESET flashes on the display.)
Klem BC 1009 STS fast på holderen. Nullet i hastighedsvisningen
blinker. Til pairing af hastighed findes der 2 muligheder:
1
Kørsel i frihjul, som regel er modtageren pairet med senderen
efter 3 til 4 hjulomdrejninger.
2
Drej forhjulet til KMH-visningen holder op med at blinke.
Når BC 1009 STS fjernes fra holderen, afbrydes forbindelsen.
1
2
14
DK
GB
US
5 Synchronisation / Pairing