Beko WMD 25080 R - Инструкция (Страница 21)

21
tion. Seals on machine side must be connected filter
cannal.
After connecting the hose, check all connections for
leaks In order to eliminate any risk due to water leakage
keep the taps off when machine is not used.
Your machine will operate efficiently if the water from
tap is minimum 1 and maximum 10 bars. Practically 1
bar means 8 liters of water in one minute when tap is
fully on.
Connect hose to the machine. Tighten bolts with hand
power, do not use spanner.
Double inlet models can be used with blind cap as a
single inlet machine. Connect blind cap to hot water
inlet. Seal must be for stopping water leakage.
Do not connect single inlet machine to hot water. If
machine is connected with Y part to a double inlet
and over 40˚C for single inlet machines, machine may
switch to protection mode.
b) Water drain hose
Water drain hose could be placed either at the side of the
bath tub, or directly to the drain. The hose should not be
bent. Water drain hose should be secured with the holder
so that it would not fall down on the ground.
The hose should be placed between 40 and 100 cm. from
the ground.
Water drain hose could be placed directly to the drain
water inlet.