Hyundai H-1544 - Инструкция (Страница 3)

2 3
Instruction manual Instruction manual
Important safeguards
• The instruction manual contains important
operating and maintenance instructions. For
your safety, it is necessary to refer the manual.
Keep the manual for use in future.
• Do not hit or drop the unit.
• Do not expose the unit to vibration,
direct sunlight, too high or low temperature or
humidity.
• If you are not going to use the unit within
a long period of time, remove the batteries to
avoid their leakage.
• Do not disassemble the unit yourselves.
Refer servicing to qualified service personnel.
Power supply
Battery operation
• Insert 1 x 9 V battery (not included) to
the terminal inside the battery compartment.
Your set will not work normally from the battery
supply, but there is now the advantage that, in
case there is a mains current failure, your clock
will continue to work. The clock display will not
light up, the clock time will be held in the clock
memory by the battery back-up system. This
enables you to move the set from place to place
without re-setting the clock every time. The
battery back-up system is only meant to be used
from short temporary power failures. For longer
durations the battery may become exhausted or
there may be some deviation in accuracy.
• When the battery is exhausted, it should
be removed from the set to prevent leakage.
If you do not wish to take advantage of the
battery back-up system, your set will work
normally without a battery. However, if
disconnected from the mains, the clock figures
will flash when the mains are re-connected and
you must re-set the clock.
AС operation
• The appliance is for household use only.
• Before the first connecting of the appliance
check that voltage indicated on the rating label
corresponds the mains voltage in your home.
• Insert the plug into the power supply.
• The set is now working as an electronic
clock.
Setting the clock
• Press and hold button.
• Do not release button; press button
or button to set the clock display to the
correct time.
• Release all the buttons when finished the
setting.
Radio operation
Tuner operations
• To turn on the radio slide AUTO/OFF/ON
switch to ON position.
• Slide FM/AM switch to AM or FM position.
• Adjust the program using TUN regulator.
• Use VOL regulator to adjust volume level.
• To turn off the radio slide AUTO/OFF/ON
switch to OFF position.
• To obtain better FM signal reception,
extend the FM wire antenna to its full length.
• This unit is equipped with a built-in ferrite
antenna. Select the best orientation of this unit
to get a better reception of AM signal.
Sleep to music
The radio can be set to play and to switch off
automatically after a preset time.
• Slide AUTO/OFF/ON switch to OFF or
AUTO position.
• Press button once. You can have 59
minutes playing the radio to accompany you
to sleep.
• To set for a desired period of sleep
(maximum 1 hour 59 minutes), simply press
and hold
button and then press button
or button to set the desired period of the