ASSISTANT AT–1070 - Инструкция (Страница 9)

. . . Y O U R A S S I S T A N T
p. 7
BATTERY FITTING
1. Your translator is powered by main two CR2032 lithium batteries and databank memory power by
one CR2032 lithium battery. When the power level of the batteries is low, display low battery. If it happens,
replace the main one battery for translator immediately.
a) Turn off the machine.
b) Slide the switch to right hand side to open,
then pull off the battery door of main compartment.
c) Remove the old batteries and replace them with new ones, ensure
that the positive (+) poles are on top, same as the symbol indicated inside
the battery compartment.
d) Make sure that the batteries make a good contact with the metal
plates in the battery compartment.
e) Pull the battery compartment inside the cabinet.
The battery for databank memory is not required to replace unless your main battery was always in very
low power. In case, replace the main 2 batteries first and keep them in the battery compartment, then to
replace the battery of databank. With this way the memory in your databank will not be lost during the battery
replacement. To replace the memory battery, unscrew the battery cover and replace new one.