English, Useful tips, Storage – Инструкция по эксплуатации Binatone SI-4060
Страница 7: Selection of temperature settings
7
77
77
ENGLISH
Warning:
In areas with very hard water it is recommended
that you regularly remove scale from the appliance to
maintain it in good working order. Excess lime scale
may result in damage or malfunction of your product.
If in your area the water is soft and you have average amounts
of clothes to be ironed then we recommend you to de-scale every 6
months. If the water in your area is very hard or if you iron fre-
quently, then we recommend you de-scale once a month.
Your iron has a self-cleaning function, which allows you to clean
the internal parts of the appliance from scale or dust. To use this
function perform the following procedure:
1. Set the steam control knob (9)
(9)
(9)
(9)
(9) into the «0» position.
2. Fill the tank (5)
(5)
(5)
(5)
(5) with water to the «Max» level.
3. Place the iron in a vertical position and plug it into the mains
supply outlet.
4. Set the temperature control knob (10)
(10)
(10)
(10)
(10) into the «Max» position.
The light indicator (11)
(11)
(11)
(11)
(11) will light up showing that the iron is
being heated to the desired temperature.
5. When the iron reaches the maximum temperature, the light
indicator (11)
(11)
(11)
(11)
(11) will go out.
6. Whilst holding the appliance horizontally over a sink, set the
steam control knob (9)
(9)
(9)
(9)
(9) into the «Self-Clean» position. Hot
steam will discharge from the sole plate (12)
(12)
(12)
(12)
(12) removing the
scale and dust. If the blast of steam becomes weaker, set the
control knob (9)
(9)
(9)
(9)
(9) into the «0» position and wait for 12-15
seconds until the iron gets hot again. Then once again set the
control knob into the «Self-Clean» position.
7. When the water tank (5)
(5)
(5)
(5)
(5) is completely empty, set the steam
control knob (9)
(9)
(9)
(9)
(9) into the «0» position.
8. Put the appliance into a vertical position and re-heat the iron.
9. To complete the cleaning process; Iron a piece of a clean old
cotton cloth in order to clean the sole plate (12)
(12)
(12)
(12)
(12) of any remain-
ing dust and scale and to evaporate the remaining water. When
you have finished ironing, always switch the appliance off and
disconnect from the electrical supply.
Storage
Before storing the iron, make sure it is disconnected from the
mains supply outlet and is completely cooled down. Set the tem-
perature control knob and the steam control knob into the «0»
position. Drain the remaining water from the tank (5)
(5)
(5)
(5)
(5) by opening
the cover (4)
(4)
(4)
(4)
(4) and holding the iron upside down over the sink. Store
the appliance in the upright standing position.
USEFUL TIPS
Selection of temperature settings
!
Before ironing, we recommend that you orga-
nize your clothes, into the types of material and
the recommended temperature settings.
!
We recommend that you start ironing, using the
lower temperature settings first: the appliance
gets hot quicker than it cools down.