DUNE TV-301 - Инструкция (Страница 14)

14 Dune HD TV-301 Quick Start Guide
Switching the Player On and Off
To put the player into the standby mode, press the «POWER» RC button. To exit the standby mode, press this buttons
again.
Depending on the player settings (see the player setup menu), the «hardware standby» or «software standby» mode
may be used. In the «hardware standby» mode, almost complete power-off takes place and the player consumes
almost no power. In the «software standby» mode, the player produces no signal on the video output, but is still
functioning. For example, if you have some storage devices connected to the player, you may still access them from
network («NAS» function of the player). Exiting the «software standby» mode takes just a few seconds. When the
player is in the «software standby» mode, it still consumes significant power. It is not recommended to keep the player
in the «software standby» mode for a while if you do not need it.
To switch the player off completely, disconnect the power plug.
NOTE: After switching off the player completely or putting the player into the «hardware standby» mode,
it is recommended to wait about 1 minute before switching it on again.
NAS (Network Attached Storage)
You can access storage devices connected to the player from the local network using FTP and SMB protocols.
On a Windows PC, just type «ftp://ip_address» or «\\ip_address» in the Windows explorer, where «ip_address»
is the IP address of the player.
Wi-Fi
If you player does not include a built-in Wi-Fi adapter, you can use a USB Wi-Fi adapter to connect the player to the
local network via Wi-Fi.
Please see here for the information on supported USB Wi-Fi adapters: http://dune-hd.com/support/hw_compat/