Elenberg WM-4515 - Инструкция (Страница 11)

11
Prepare
1. The machine should be placed on flat ground.
2. This machine requires to use the ambipolar plug to assure the safety of
the machine when working. Do not connect the ground wire to the water
pipe, gas pipe, heating pipe and so on.
3. Lay down the overflow hose. (Do not lay down the hose when machine is
on up drain function.)
4. Use the water hose to connect the water tap to the water inlet.
5. According to the material and weight of cloth, adjust the level of water.
6. Switch on power.
Washing
1. Put the clothes and correct amount of detergent into the tub. (Excessive
detergent will make it difficult to get rid of the suds and insufficient rins-
ing may result)
2. Turn on the tap valve, inlet water and adjust the water level according to
the requirement.
3. Set the wash drain-switch to strength or tender according to the material
and weight of clothes.
4. Set the wash timer knob to the proper position and start to wash.
5. After wash, set the wash-drain switch to the drain position to drain off
water.
Spin-drying
1. After drain off water, put the clothes to the right spin-tub and hold down
the clothes.
2. Put down the safety lid and spin-dry lid in turn.
3. Set the spin-dry timer to the proper time according to the clothes .
Drain washing
1. After drying ,inlet water to the spin-dry barrel for 20-30 seconds.
2. According to the spin-drying process, dry the clothes for 1 minute, re-
spin for 1-2 minutes .
Rinsing
1. After drying as the spin-dry tub finally stop, open the spin-basket, safe-
ty lid and spin-dry lid in turn, take out the clothes to the washing tub
and prepare to rinse.
2. Besides no more putting the detergent, the rinsing process have no dif-
ference with the washing process.
NOTE:
Washing and spinning can be operated at the same time.
WASHING INSTRUCTION