Saturn ST-HC1540 - Инструкция (Страница 2)

3
GB
HAIR CLIPPER
Dear Buyer!
We congratulate you on having
bought the device under trade
name “Saturn”. We are sure that
our devices will become faithful
and reliable assistance in your
housekeeping.
Avoid extreme temperature
changes. Rapid temperature
change (e.g. when the unit is
moved from freezing temperature
to a warm room) may cause
condensation inside the unit and a
malfunction when it is switched
on. In this case leave the unit at
room temperature for at least 1.5
hours before switching it on.
If the unit has been in transit,
leave it indoors for at least 1.5
hours before starting operation.
Description of the Set
1. Cutting head
2. Telescope styling attachment
3. Trimming length setting ring
4. On/off switch
5. Indicator lamp
6. Charging base
7. Adapter
8. Maintenance oil
9. Cleaning brush
10. Charger socket
11. Styling attachment mounting lock
Using the Appliance
The battery-powered MG9 clipper is
designed for hair trimming. Charge
the battery before using the appliance
for the first time.
Battery Charging
The battery can be charged in two
ways:
- by connecting the adapter (7)
directly to the clipper charging socket
(10);
- by placing the clipper in the charging
base (6) and connecting the adapter
(7) to the socket in the charging
base.
In both cases, set the switch (4) in
the OFF position (clipper off) before
charging. The indicator lamp (5) goes
on to indicate that the charging is on.
The time of the first charging is 12
hours.
IMPORTANT. The indicator lamp
(5) does not go off after the
appliance has been charged.
Charging the battery for over 12 hours
reduces its life span.
If the appliance is not used for a
longer period of time, it is
recommended to charge the battery at
least once every half a year. Failure to
charge the battery for a period of over
6 months also reduces its life span.
Hair Clipping
- Make sure the appliance is clean,
correctly assembled and oiled.
- Before clipping the hair, comb it to
make it more natural.
- to install the attachment (2), slide
it into the locks (11), photo 1.
You can use the attachment to trim
hair to the length range of 4-16 mm.
Take off the attachment to shorten
the trimming length.
Use the revolving ring (3) to set up
the hair trimming length.
The rotating ring (3) allows for
control of hair length.
- It is recommended to start clipping
with the use of the comb head for
longer hair.
- Clip small areas by moving the
appliance slowly through the hair.
- Start clipping from the neck upwards
or from the forehead and the temple
upwards.
- Hold the appliance gently under the
hair, so that the comb heads are
pointed upwards and lie flat on the
head.
Use the switch (4), position „ON” to
switch on the clipper. Additionally, the
indicator lamp (5) will go on to
indicate that the clipper is operating.
Do not use the appliance for
clipping wet hair.