Saturn ST-CM7086 Tirana - Инструкция (Страница 4)

6
3. Fill 1/4 of milk into heat resistant jug. The best results will be achieved by using fresh
milk at refrigerator temperature. It is not preferable to use skim milk.
4. The jug should only be filled up to 2/3 of its capacity m order to prevent the milk from
frothing over.
5 When the espresso is ready start to froth the milk
6. Position the jug under the steam pipe so that the steam nozzle is just below the surface
of the milk.
7. Open the steam nozzle by turning the steam control knob anti-clockwise. And the steam
pipe can't work for more than 3 minutes continuously.
HOW TO PRODUCE STEAM ONLY
1. When using the machine to produce steam only .open the steam control (1) before you
switch on in order to avoid any over-pressure in the water reservoir.
2. The espresso coffee maker may be used to produce steam only by using the closing
filter (11).
3 It is important that the machine is always supervised while it is switched on.
4. Place the closing fitter (10) into the filter holder (5).
5. Fill the water reservoir (4) with one to two cups of water and close the water reservoir
lid (3).
6. Fill a heat resistant jug with the required amount of milk or any other beverage to be
healed.
The jug used should only be filled up lo Iwo thirds of its capacity in order to prevent the
milk/beverage from frothing over.
7. Position the jug underneath the steam pipe so that the steam nozzle is just below the
surface of the milk/beverage. Now open the steam control knob (1) and switch the
machine on.
7
8. The steam control knob may be closed for a moment in order to heat another jug of
milk. But don't use it continuous exceed 3 minutes.
9. Finally, switch it off and unplug the machine until there is no any steam out.
CLEANING AND CARING FOR YOUR ESPRESSO MACHINE
1 BEFORE cleaning any electrical appliance. Always make sure that plug has been
removed from the main supply outlet.
Wipe the body of the espresso machine with a clean damp cloth. Do not use harsh abrasive
cleaners.
2 STEAM NOZZLE-Remove the nozzle from the steam pipe and clean it together with the
accessories.
3. ACCESSORIES-Wash the accessories. The filter and the filter holder in warm soapy
water (not in dishwasher).
DESCALING
In order to maintain the excellent quality of your espresso machine we recommend the
following.
To prevent build-up of deposit especially in hard water areas leave the machine empty
after use espresso machine should regularly be discalced and we recommend the following
intervals:
NORMAL WATER; every 6 months Reminder:
1. This Espresso machine is only for household use.
2. If the supply cord is damaged, it must be replaced by the manufacturer or its service
agent or similarly qualified person in order to avoid hazard.