Saturn ST-EK0032 - Инструкция (Страница 3)

4
boiled, the red indicator turns off and
the green indicator lights on signalling
the keep warm state (within 75-95 °C).
6. Under the keep warm state, if you
need to re-heat the water, just press
"REBOIL" switch. In this process, the
green indicator lights off and the red
indicator turns on for approximately two
(2) minutes. After reboiling, it returns to
the keep warm state. It will not keep
warm if you will unplug from the power
source.
7. When dispensing hot water, press the
PRESSURE PAD with enough force to
bring out water from the airpot.
Exercise caution and extreme care when
dispensing hot water from the airpot to
prevent accidents and burn injuries.
Description
Cleaning and Maintenance
· When cleaning the airpot, make sure
to unplug from the power source and
the hot water has cooled down
completely before taking it out from the
airpot. It is advisable to clean the airpot
inside and outside before using for the
first time.
· Cleaning the airpot should be
scheduled once a month or as desired to
ensure water quality and to lengthen
service life of inner pot.
· When the airpot is not going to be
used for a long time, it should be
cleaned and dried before sealing in a
plastic bag and stored in a safe, dry
place.
Clean the inner pot
· Rust stains, scales, milky white
deposits are due to mineral elements
from the water and may form in the
inner pot wall and eventually corrode it
in time.
· If not properly and regularly cleaned,
the deposits formed on the wall may
hardened permanently and this will
cause operating problems. For
examples, noticeable sound when
boiling, different water taste, etc.
·
1. Clean it with soft foam or sponge and
rinse well.
2. Clean with citric acid every one to
three months or as desired.
5
Clean the top cover and body
· Do not use abrasive detergent, strong
chemicals, solvents or cleaning agent
when cleaning the plastic components.
·
1. Clean the top cover and body with
semi-moist, soft peferably cotton cloth.
2. Afterwards use dry, soft cotton cloth
to finish cleaning the parts. Notes:
· Do not clean the parts under running
water or soak it in water.
· Never invert the airpot bottom up
when cleaning.
Guidelines for Safety and Durability
Simple Troubleshooting
· If there is any abnormal phenomenon, please carefully read instruction manual again.
· Never attempt to take the product apart by yourself
Trouble Troubleshooting
Not working Please check if you have plugged it or not.
Please check if you added water after the automatic
power-off
protection due to boiling without water.
Please check if a sudden and short power interruption
caused the abnormal electricity supply.
No water out There is something wrong with the water dispensing
motor. Please contact our nearest service center
about the trouble.
Water
pouring by
itself
Please check if there is a short circuit.
Please check if you filled excess water on the inner
pot.
Indicator is
normal but does
not boil
The short circuit of the heat circle.
Please contact our nearest service center about the
trouble.
Boiling but
cannot keep
warm The temperature control is damaged.
Please contact our nearest service center about the
trouble.
Low water
temperature
in Keep-
Warm state
The temperature control is damaged.
Please contact our nearest service center about the
trouble.
Water pouring
out by itself
after boiling
Please contact our nearest service center about the
trouble.
Water leaking The connecting silicon pipe or stainless steel inner
tube control is damaged.
Please contact our nearest service center about the
trouble.
Cannot Reboil
from Keep
warm state
The controller or soft touch switch is damaged.
Please contact our nearest service center about the
trouble.
Any other servicing should be performed by an authorized service representative.