Инструкция по эксплуатации Saturn ST-EK8034
Страница 3
4
If you want to disconnect appli-
ance from socket (in case of pro-
longed non-using), then the power
cord is disconnected with dry
hands directly by plug itself, and
not the wire. Otherwise it can re-
sult in rupture of cable or elec-
tric shock. Disconnect appli-
ances from socket after use, as
well as during cleaning or
movement.
Do not lay the power cord near
sharp corners and edges, close to
sources of heat (stoves, gas or
electric fryers). Do not immerse
into
water appliance
itself,
power cord or plug. This can
lead to malfunctions, which are
not covered by guarantee.
It is prohibited to use the appli-
ance and packing materials for
children games. Do not leave
small children unattended near
the appliance during its opera-
tion. Keep appliance in place in-
accessible for children.
Do not allow to use appliance to
people with limited physical or
mental
capabilities
(including
children) before instructions for
safe use of the appliance is ex-
plained to them and is understood
by them. The appliance may be
used 12 only under supervision
of adults. Do not leave the ap-
pliance connected to the mains
without attendance.
It is prohibited to use appliance
outdoors. There is a danger of
fault due to rain or other
weather conditions.
To provide safety during connect-
ing to the mains, the appliance
should be grounded. The appli-
ance should be connected only to
grounded sockets. Otherwise the
appliance will not correspond to
the requirements of protection
against electric shock.
Watch that the cord will not twist
and bend over the edge of table,
children contact it or stumble over
it. Place appliance only upon dry
even surface. Also observe gen-
erally accepted safety rules dur-
ing work with appliance.
It is prohibited to use appliance in
case of any malfunctions. If it is
faulty or functions incorrectly,
disconnect it from mains, taking
plug out of the socket, and ad-
dress the authorized service cen-
ter.
Unassisted repair or modification
of appliance is prohibited. All
works related to maintenance and
repair should be carried out by au-
thorized service center. The work
carried out unprofessionally can
lead to fail, injuries and prop-
erty damage.
Use the appliance for intended
purpose; it is prohibited to use it
for goals, not described in the pre-
sent manual. Do not use the ap-
pliance in reservoirs that are
subjected to direct heating; and
it is prohibited to pour boiling
liquid into bowls.
The appliance may be used only
when it is completely assembled.
The appliance is to be used in
domestic conditions; the appli-
ance is not designed for indus-
trial use.
Before cleaning the appliance
make sure that it is disconnected
from the mains and the appliance's
5
components rotation has stopped
completely. Always keep the ap-
pliance clean. Keep this Manual,
so you can use it in the course of
consequent operation.
Use soapy water, sponge or soft
fabric Tor cleaning of the appli-
ance. Do not use chemical and
abrasive agents for cleaning.
Do not touch hot details of a tea-
pot during its work or at once at
the work termination. It can lead
to a bum.
Do not use any other network
cords except a cord which is de-
livered complete with the electro
device, and also do not use this
cord for other electric devices.
If the electro device is not used,
take out a plug of a network cord
from the electric socket. Default
of this requirement can lead to
traumas, bums, defeat by an
electric current, or to current
leak, owing to damage of electric
isolation.
BEFORE USE
1. Carefully take the thermo pot out of the
box
2. Remove all packing materials, including
various stickers.
3. Clean the frame and base of the kettle
with wet cloth, then let it dry.
Before the first use fill and boil
the water. Than pour off the wa-
ter and repeat this action two
times.
II. OPERATION OF THE KETTLE
1.
Establish the device
on an equal surface
and insert a plug
into the socket. At
installation watch
that hot steam at
thermo pot boiling
did not get on furni-
ture, home appli-
ances, walls etc.
2.
Opening, removal
and cover instal-
lation.
1. Lift the handle of
opening of a cover.
2. Open a cover
upwards. Keep the
handle of opening of
a cover in the top
position, press the
button of removal of
a cover and uncover
at an angle upwards.
For cover instal-
lation
into
place
execute actions for
cover removal in
return sequence. For
cover closing press
it from above before
click.