Saturn ST-EC0154 - Инструкция (Страница 2)

2 3
GB
NUT MAKER
Dear Buyer!
We congratulate you on having
bought the device under trade
name “Saturn”. We are sure that
our devices will become faithful
and reliable assistance in your
housekeeping.
Avoid extreme temperature
changes. Rapid temperature
change (e.g. when the unit is
moved from freezing temperature
to a warm room) may cause con-
densation inside the unit and a
malfunction when it is switched
on. In this case leave the unit at
room temperature for at least 1.5
hours before switching it on.If the
unit has been in transit, leave it
indoors for at least 1.5 hours be-
fore starting operation.
IMPORTANT SAFEGUARDS
• READ ALL INSTRUCTIONS
• Make sure the voltage in your outlet
is the same as the voltage indicated
on the appliance’s rating label.
• Turn the power off and remove the
plug when the appliance is not in use
and before cleaning. Remove by
grasping the plug – do not pull on the
cord.
• Do not use your appliance with an
extension cord unless this cord has
been checked and tested by a qualified
technician or service person.
• Close supervision is necessary when
your appliance is being used near chil-
dren.
• Young children should be supervised
to ensure that they do not play with
the appliance.
• Never leave an appliance unattended
while in use.
• Do not use an appliance for any pur-
pose other than its intended use.
• Do not place an appliance on or near
a hot gas flame, electric element or
any other appliance.
• Do not let the power cord of an ap-
pliance hang over the edge of a table
or bench top or touch any hot surfac-
es.
• Do not operate any appliance with a
damaged has malfunctioned or has
been damaged in any manner. In order
to avoid the risk of an electric shock,
never try to repair the Nut Maker
yourself. Take it to an authorized ser-
vice station for examination and re-
pair.
• Do not use outdoors.
• Do not use for commercial purposes.
• Do not immerse the appliance in
water or any other liquid.
• Service life – 2 years
BEFORE THE FIRST USE
Remove all packaging materials.
Clean the baking plates with a damp
cloth or sponge and wipe them dry.
Slightly grease the baking plates with
a little cooking oil.
Take care to prevent water from run-
ning into the appliance.
PARTS IDENTIFICATION
Before using your nut maker for the
first time, you should become familiar
with all of the parts. Read all Instruc-
tions and Safeguards carefully.
1. Lid Latch
2. Upper Housing
3. Power Indicator
4. Ready Indicator
5. Bottom Housing
6. Power Cover
7. Upper Plate
8. Bottom Plate
USING YOUR NUT MAKER
• Inset the pin plug into the power
outlet, you will notice that the ready
indicator will go on, indicating that the
nut maker has begun preheating.
• Allow your nut maker to pre-heat
until the ready indicator goes out. This
indicates that the cooking plates have
reached the correct temperature for
cooking.
• For best results, lightly spray the
cooking plates with a cooking oil spray
before using. This will assist in the
removal of the donuts after cooking.