Saturn ST-EK7014 Glass - Инструкция (Страница 3)

General safety instructions
Before commissioning the device please read the instruction manual carefully
Please keep these instructions , the guaranty certificate , the sales receipt and , if possible ,
the carton with the inner packaging !
The device is intended exclusively for private and not for commercial use !
Always remove the plug from the socket whenever the device is not in use , when
attaching accessory parts , cleaning the device or whenever a disturbance occurs . Switch
off the device beforehand . Pull on the plug , not on the cable .
In order to protect children from the dangers of electrical appliances , never leave them
unsupervised with the device. Consequently , when selecting the location for your device ,
do so in such a way that children do not have access to the device . Take care to ensure
that the cable does not hang down .
Test the device and the cable regularly for damage . If there is damage of any kind , the
device should not be used .
Do not repair the device yourself , but rather consult an authorized expert .
For safety reasons a broken or damaged mains lead may only be replaced by an equivalent
lead from the manufacturer , our customer service department or a similarly qualified
person .
Keep the device and the cable away from heat , direct sunlight , moisture , sharp edges and
suchlike .
Never use the device unsupervised! Switch off the device whenever you are not using it ,
even if this only for a moment .
Use only original accessories.
Do not use the device outdoors.
Under no circumstances must the device be placed in water or other liquid , or come into
contact with such . Do not use the device with wet or moist hands .
Should the device become moist or wet , remove the mains plug from the socket
immediately . Do not reach into the water .
Use the device only for the intended purpose .
This appliance is not intended for use by persons (including children) with reduced
physical,sensory or mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction concerning use of the appliance by a person
responsible for their safety. Children should be supervised to ensure that they do not play
with the appliance
.
Special safety instructions for this machine
Use only cold water when filling.
The water level must be between the MAX. and MIN. marks !
Switch the machine off before removing it from the base .
Always ensure that the lid is tightly closed .
The base and exterior of the machine must not become wet .
First use of the machine
Before using the machine for the first time water should be boiled in it twice without any
additives .
1. Place the machine on a flat surface.
2. Fill the kettle with water. Do not overfill! Use the water level indicator.
3. Place the kettle flush on the base.
4. Electrical connection
Check whether the electrical voltage that you intend to use is the same as that of the
machine . Details are to be found on the label on the base.
Only connect the machine to a properly installed 220-240V ~50/60Hz safety socket.
5. Switch the machine to position “1”. To start heating and indicator will light
6. After boiling the machine switches off automatically and indicator light will go off
Disconnect the machine from the mains electricity supply.
Do not press up the lid when pouring.