Инструкция по эксплуатации Saturn ST-EK8411

Страница 2

Advertising
background image

GB

Electric Kettle

Dear Buyer!

We congratulate you on having

bought the device under trade

name “Saturn”. We are sure that

our devices will become faithful

and reliable assistance in your

housekeeping.

Avoid

extreme

temperature

changes. Rapid temperature change

(e.g. when the unit is moved from

freezing temperature to a warm

room) may cause condensation

inside the unit and a malfunction

when it is switched on. In this case

leave the unit at room temperature

for at least 1.5 hours before

switching it on.

If the unit has been in transit, leave

it indoors for at least 1.5 hours

before starting operation.

Important Safeguards

When using electrical appliance, the

following

basic

safety

precautions

should always be followed:

1.

Read all instructions.

2.

Before use checks that the voltage

power corresponds to the one

shown on the appliance nameplate.

3.

Unplug from outlet when not in use

and before cleaning. Allow too cool

before cleaning the appliance.

4.

Do not let cord hang over edge of

that table or counter, or touch hot

surface.

5.

Place the appliance on the flat

surface. Do not place on the heated

surface.

6.

To protect against electric shock, do

not immerse cord, plug, power base

and kettle in water or other liquid.

7.

Close supervision is necessary

when any appliance is used by or

near children.

8.

Do not touch hot surface. Use

handle or knobs only.

9.

Do not operate any appliance with a

damaged cord or plug or after the

appliance malfunctions. Return the

appliance to the nearest authorized

service center for examination,

repair or adjustment.

10. If the supply cord is damaged, it

must

be

replaced

by

the

manufacturer or its service agent or

a similarly qualified person in order

to avoid a hazard.

11. Do not use outdoors.

12. Do not use the appliance for other

than intended use.

13. The kettle can only use with the

stand provided.

14. If the kettle is overfilled, boiling

water may be ejected.

15. This appliance is not intended for

use by persons (including children)

with reduced physical, sensory or

mental capabilities, or lack of

experience and knowledge, unless

they have been given supervision

or instruction concerning use of the

appliance by a person responsible

for their safety. It is not advised to

use this appliance by children under

14.

16. Children should be supervised to

ensure that they do not play with

the appliance.

17. Save these instructions.

Operation

It is recommended that operate the

kettle several times following the below

instruction and discard off the water

before first use. This will remove the

material or dust remained in the

appliance which is caused by the

manufacturing process.

1. Open the lid by pulling the Lid

upwards and fill water into the

kettle.

Then

replace

the

lid

otherwise the kettle could not be cut

off power automatically after water

being boiled. Alternatively the water

can be filled through the spout.

2. Caution: the filled water level must

be between the Max and Min level

as indicated on the housing. Too

less water will do damage to the

heat element and if the water is

overfilled, boiling water may be

ejected.

3. Replace the kettle on the Power

Base and connect to power supply.

Position the kettle so that the spout

of kettle is facing away from you.

4. Press down the switch to “1”

position and the lamp will be

illuminated. And water begins to be

heated up. Do not remove the lid

while the water is boiling.

5. Power will be cut off automatically

and switch will be back to “0”

position once water has been boiled.

And the lamp will be off.

6. The

boiling

process

can

be

terminated at any time by lifting the

kettle off the Power Base.

Caution:

·

Never operate the appliance empty.

In the event of this case occurred,

the thermal cut-off inside the kettle

would operate to cut off power

automatically. Unplug the appliance

and let it completely cool down.

·

Never touch the stainless housing

during operation as scalding may

occur.

2

3

Advertising