Vitek VT-1358 - Инструкция (Страница 10)

РУССКИЙ
НАПОМИНАНИЕ
Стригите волосы свободными
медленными движениями.
Сначала
состригите небольшое
количество волос. Позже вы всегда
можете
подстричь еще некоторое
количество волос.
При работе чаще причесывайте волосы,
чтобы получить тот стиль прически,
который вам нужен.
При стрижке волос с помощью данной
машинки
предпочтительнее, чтобы
волосы были сухими, а не влажными. При
сухих
волосах значительно проще
контролировать количество снимаемых
волос.
НАЧАЛО СТРИЖКИ ВОЛОС
Стрижка волос требует навыка, поэтому при
первых попытках стрижки лучше оставить
волосы подлиннее, пока вы не привыкнете к
19
ENGLISH
3. For longer hair on top, use the comb provided and
lift hair on the top of the head. Cut over the comb,
with the hair lifted or hold the hair between the fin
gers to lift it and cut it to desired length (see dia
grams 5 and 6). Always work from the back of the
head. You can cut the hair shorter gradually by
reducing the space between the comb/fingers, and
the head. Comb out trimmed hair and check for
uneven strands.
STEP 5 THE FINISHING TOUCH
1. Finally, use the taper lever without an attachment
comp for close trimming around the base of the
neck , the sides of the neck and the ears.
2. To produce a clean straight line at the sideburns,
reverse the hair clipper by turning the reverse side
uppermost (see diagram 7).
3. Press the clipper at right angles to the head, tips of
the blades lightly touching the skin and work down
wards. This way you will obtain, as a clean cut as
would be given by a razor.
SHORT TAPERED STYLES 'FLAT TOPS' AND
SHORT CUTS
1. Starting with the longest attachment comb (12mm
), cut from the back of the neck to the crown. Hold
the attachment comb flat against the head and
slowly move the clipper through the hair, as shown
(see diagram 8).
2. Use the same procedure from the lower side to the
upper side of the head, as illustrated. Then cut the
hair against the direction in which it grows from the
front to the crown and then level the cut with the
sides.
3. To give a 'flat top' look, the hair on top of the head
must be cut over the top of a flat comb rather than
10
Рисунок 1
1358.qxd 15.09.03 10:55 Page 20