Vitek VT-3630 - Инструкция (Страница 5)

• Время от времени протирайте магнитолу влажной тканью. Не
используйте для чистки химические средства.
• Качество работы магнитолы зависит от качества кассет. В случае плохой
перемотки, заедании кассеты рекомендуется во избежание порчи
магнитолы изъять кассету из пользования.
• Не используйте кассету, если она была повреждена или запутана.
• Не оставляйте кассету в проигрывателе, если Вы не собираетесь ее
прослушивать, особенно при жаркой окружающей температуре.
• Оберегайте кассеты от пыли, грязи, прямых солнечных лучей, не храните
их рядом с электрическими двигателями и магнитами.
• При снижении уровня высокочастотных сигналов и некачественном
воспроизведении фонограммы необходимо очистить от пыли и грязи
рабочие поверхности магнитной головки, тон валов и прижимных
роликов. Для этого протрите их неворсистым тампоном, пропитанным
спиртом, или используйте чистящую кассету.
• Прикосновение к магнитной головке металлическими предметами
недопустимо.
СХЕМА ПОДКЛЮЧЕНИЯ МАГНИТОЛЫ
РУССКИЙ
12
once the station is found, it pauses for about 5 seconds, storage of the station can be per
formed within this period, after then, the radio will resume scanning. To stop this operation,
press this button once more.
OTHER FUNCTIONS
17. CD INPUT (OPTIONAL)
Connect external CD signal to the CD input jack locked at the rear of the unit, then press the
CD button at the front panel. To cancel CD mode, press Band button to select radio mode or
Tape button to select cassette play mode.
18. DISPLAY BUTTON
Press this button to display clock, the clock will remain for about five seconds, then return to
previous display mode.
CLOCK ADJUSTMENT
Press Display button for more than 2 seconds, the LCD will flash, this shows that the clock is
under adjustment mode.
Under clock adjustment mode, press the manual tuning up button to adjust hour or the man
ual tuning down button to adjust minute. After adjustment is completed, press Display but
ton again to return to normal operation, or it will resume to normal automatically if no key is
pressed for about 8 seconds.
NOTE: The clock keeps working even though the ignition key is off.
BACKUP POWER CONNECTION
The violet cable of the main unit must be connected directly to the car battery (+) or to a (+)
point where +12V DC is always alive. Current drain of the backup circuit is very small that it
does not cause battery discharge problem even if the car is parked for a long period.
POWER ANTENNA ACTIVATOR
This is used when you have an automatic power antenna. When the unit is turned on the
antenna extends automatically, when the unit is turned off, the antenna retracts automati
cally.
19. RESET BUTTON
If the unit operates abnormally or displays wrong letters on the LCD, press the reset button
for more than 2 seconds to reset the microprocessor. The Reset button is located behind the
detachable panel.
MAINTENANCE
For System
The following suggestions help you care for the product so that you can enjoy it for years.
1.
Keep the product dry. If it does get wet, wipe it dry immediately. Liquids might contain
minerals that can corrode the electronic circuits.
2. Keep the product away from dust and dirt, which can cause premature wear of pans.
3. Handle the product gently and carefully. Dropping it can damage circuit boards and
cases, and can cause the product to work improperly.
4. Wipe the product with a dampened cloth occasionally to keep it looking new. Do not use
harsh chemicals, cleaning solvents, or strong detergents to clean the product.
5. Use and store the product only in normal temperature environments.
High temperature can shorten the life of electronic devices, damage batteries, and dis
tort or melt plastic parts.
For Tape Player
Periodic cleaning of the tape head and capstan shaft will ensure good reproduction of music
and trouble free operation. Cleaning of the tape head should be done every 20 to 30 hours
5
ENGLISH
3630.qxd 28.10.03 15:13 Page 10