Vitek VT-1353 - Инструкция (Страница 4)

25
ENGLISH
POWER SCREW
The power screw permits you to adjust the power. It
has been adjust before leaving the factory.
However, if the voltage in your home is low, you may
need to re adjust it.
To adjust, use a screwdriver or a thin coin to turn
power screw in clockwise direction until the arm
strikes the coil, making a noise. Then slowly turn
power screw out (counter clockwise) just until
noise stops. This is maximum power setting.
BLADE LEVER
The lever is conveniently located near your thumb
(if you're right handed) so it can easily be adjusted
while the clipper is in your hand.
The lever adds versatility to your clipper by allowing
you to gradually change the closeness of your cut
without an attachment comb.
When the lever is in the uppermost position, the
blades will give you the closest cut and leave the
hair very short. Pushing the lever downward gradu
ally increases the cutting length.
In its lowest position, the lever will leave the hair
approximately
the same
length as a N1 comb.
The lever will also extend the
use of your blades since a dif
ferent cutting edge is used in
each , setting.
4
Vt-1353.qxd 07.02.03 11:16 Page 8