TIMBERK THU 30UF A - Инструкция (Страница 11)

ENGLISH
ATTENTION!
To avoid electric shock, before you disassemble the unit (take off
the tank), unplug the appliance!
Do not fill the tank other liquids, except for tap water.
Another of the liquid is harmful to internal components and leads
to failure.
Do not fill the device or reservoir for water additives such as
essential oils, fragrances, detergent, chemical medicines, warm
water (above 40 °), etc.
Otherwise, the water tank and the internal parts damaged and
the device will come to a fault.
Do not pour water directly into the interior of the device or
nebulizer.
The presence of water inside the unit may cause damage to the
device.
Do not hit or throw a water reservoir. It may be damaged, leading
to water leakage. Do not use the device in the event of a severe
blow tank.
o ATTENTION!
In order to avoid deformation and erase the working surfaces, leading
to reduced sputtering or other problems, do not use wire brushes,
talcum powder or blades to wipe the nozzle surface.
When strong shocks the water tankcan leak.
When the water leaks immediately discontinue operation of the unit
and contact your dealer.
To maintain the unit in a dry state to remove the water after cleaning
and be sure to dry the water tankand the enclosure.
Make sure that inside the water tankand the enclosure is left of water.
Before long a pause in the use of the device dry reservoir and surface of
the device, install the tank in the housing and pack the humidifier
in a plastic bag and then into the box.
Keep the instrument in a room with low humidity.
Storage device in unseasoned state leads to mold.
7. CLEANING YOUR ULTRASONIC HUMIDIFIER
The method of keeping clean:
Using purified water
Cleaning the base of unit, water tankand ultrasonic transducerevery week
Always change to use clean water.
Always drain the water tankwhen notin use.
Clean all parts of the humidifier before storing by wiping with a damp cloth,
and buffing with a dry cloth.(Except for the electrical control when the unit is
off, any part of the humidifier may be wiped with a soft damp cloth, and
buffed with a dry cloth ,ensuring the unit is unplugged.)
The methods of cleaning the connector:
To clean the dirty surface with a soft brush.
Rinse the transducerwith clean water.
The methods of cleaning the base of unit:
Clean the dirty flume with soft cloth.
If there is dirty on the surface of the protective switch of water line, using soft
brush to clean.
Wash the flume with clean water.
www.timberk.ru • ultrasonic humidifier 11