Инструкция по эксплуатации TIMBERK THU MINI 01
Страница 8
Внимание! Текст в этом документе был распознан автоматически. Для просмотра оригинальной страницы Вы можете воспользоваться режимом "Оригинал".
25. Do not use the appliance for anything other than its intended use.
26. Any repairs that need to be done to the humidifier must be referred
to an authorized Service Agent only.
27. The unit should not be left unattended in closed rooms as air could
become saturated and leave condensation on walls or furniture.
28. Do not use detergent to clean any parts containing water. The
detergent can interfere with the output of the unit if it comes into
contact with the water.
29. Always leave room door partly open.
30. This appliance is not intended for use by persons (including children)
with reduced physical, sensory ormental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safty.
Operation
1. Remove the water tank from the unit base open the cap, fill the water
tank with water, close the cap, and put the water tank on the base
correctly.
2. put the nozzle in the notch of the water tank and adjust the nozzle
away from the walls and furniture.
3. plug the humidifier into the power outlet, turn on the power switch
(Never switch it on without water) the indicator will illuminate, and
the humidifier begin working. Turn the mist setting knob to select your
desired volume
Note: It is normal if there is a little of mist overflows from the nozzle at
the beginning of working.
CLEANING YOUR ULTRASONIC HUMIDIFIER
Note: When cleaning the inside of the unit, keep the water away from
the air outlet.
The method of keeping clean:
Using purified water
Cleaning the base of unit, water tank and ultrasonic transducer every
week
Always change to use clean water.
Always drain the water tank when not in use.
Clean all parts of the humidifier before storing by wiping with a damp
cloth, and buffing with a dry cloth.(Except for the electrical control
when the unit Is off, any part of the humidifier may be wiped with a soft
damp cloth, and buffed with a dry cloth ,ensuring the unit Is
unplugged.)
The methods of cleaning the connector:
To clean the dirty surface with a soft brush.
Rinse the transducer with clean water.
The methods of cleaning the base of unit:
Clean the dirty flume with soft cloth If there is dirty on the surface of
the protective switch of water line, using soft brush to clean
Wash the flume with clean water.
OTHER FEATURES
In cold weather, windows, and even some walls may fog or develop frost
from excessive indoor humidity. If this occurs, reduce the mist
intensity setting to avoid damage from condensed water dripping on
windowsills.
Too much humidity in the room may allow moisture to accumulate on
surfaces where bacteria and fungi can grow. Collected moisture may
also harm
furniture, and walls, especially wallpaper.
To eliminate too much humidity, especially In a small room, leave the
room door open, add adjust the mist intensity control setting.
Fig. 2